i have a 1hdt swapped into a 1989 fj62. that matters because its an all 12v system.
last week was going through a drive through and had to shut it off to hear the kid on the other end. went to restart it and it won’t go! i just bumped it which is normally all i needed to do to get it running. i’d didn’t fire so i started to crank it. starter is turning things over just fine but it seems there’s no fuel. i had to get a push out to the parking lot where i figured i’d see if bumping it blew a fuse. all fuses good. now what! well low and behold it fired and i drove it home.
two days later i went to move it out of the garage to change over winter tires on my wife’s van and same deal but this time i can’t get it going. again still loads of starter but no fuel. i have tested this wire (brown one has 12v when ignition is on). i’m assuming that’s the wire to the solenoid. the blue one has nothing. the third black one i believe is tech sensor but it’s not connected to anything at this point.
dose this sound like a bad solenoid on my injection pump? what’s the next step in testing it?
last week was going through a drive through and had to shut it off to hear the kid on the other end. went to restart it and it won’t go! i just bumped it which is normally all i needed to do to get it running. i’d didn’t fire so i started to crank it. starter is turning things over just fine but it seems there’s no fuel. i had to get a push out to the parking lot where i figured i’d see if bumping it blew a fuse. all fuses good. now what! well low and behold it fired and i drove it home.
two days later i went to move it out of the garage to change over winter tires on my wife’s van and same deal but this time i can’t get it going. again still loads of starter but no fuel. i have tested this wire (brown one has 12v when ignition is on). i’m assuming that’s the wire to the solenoid. the blue one has nothing. the third black one i believe is tech sensor but it’s not connected to anything at this point.
dose this sound like a bad solenoid on my injection pump? what’s the next step in testing it?