2h oil cooler filter housing replacement from original oil filter spinner type housing to a later model 83 on oil filter housing /relief valve .
New filter housing has oil banjo oil line off housing usually directly to injection pump then front timing cove but this also has a feed I’m guessing haven’t gauged it yet direct from engine block directly to injection pump. Is it fine to tee filter housing line into same line? After market adapter etc?
New filter housing has oil banjo oil line off housing usually directly to injection pump then front timing cove but this also has a feed I’m guessing haven’t gauged it yet direct from engine block directly to injection pump. Is it fine to tee filter housing line into same line? After market adapter etc?