1980 Tranny - Speed Sensing - Internal part (1 Viewer)

[Bruce Miles]

FJ40 & manufacture date is 12/79. Replaced speedo cable, lubed sensor end in tranny. All works well up to dash, but Speedo still does not work. I guess that is a plastic gear inside. Do I have to crack the tranny to solve this problem? Any other options? Thanks in advance.

 

[Living in the Past]

Been disgusted in another lately on another thread. The driven gear can cause this problem and does not require pulling the transfer case to inspect or replace.

 

[Bruce Miles]

Been disgusted in another lately on another thread. The driven gear can cause this problem and does not require pulling the transfer case to inspect or replace.

Thanks. Searched, but cannot locate that thread. How do I find it?

 

[timmyisinthewell]

Most recently, search "speedometer/odometer not working". Sorry I'm computer challenged (old) and don't know how to show a link.

 

[pb4ugo]

The part the speedo cable screws onto at the tcase can be removed to expose the nylon gear. There's a bolt that retains a tab that locks the threaded portion into the case. Just search speedo gear, or speedo stopped or something like that.
Don't get to technical. The search looks for words, not sentences.

Speedometer/odometer not working.

Just looking for some guidance, I have replaced the cable and can spin the cable at the transfer side and get the needle to move but when attached I get nothing. Original cable was pretty rough but still intact. Yes I have searched. Thanks in advance m

forum.ih8mud.com

 

[3_puppies]

with the speedo cable removed from the transfer case, use a drill and attach inner cable to drill run drill in reverse and does the speedometer work then?
you state it is all good up to the dash but then it is brought back to the transfer case, I'm unsure where the issue is, you need to isolate the problem

 

[pb4ugo]

You also need to make sure the inner cable is engaged with the speedo in the cluster.

 

[Bruce Miles]

Most recently, search "speedometer/odometer not working". Sorry I'm computer challenged (old) and don't know how to show a link.

Found it - thanks.

 

[pb4ugo]

Found it - thanks.

I'm glad you found it.
I posted that link in my post.