1974 FJ40 Part Out

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

what are your plans for the frame?

I am looking for a pre 75 frame.
 
I am looking for a pre 75 frame.


Frame is available. Look at the pictures as I stated, a shackle reversal was started. Obviously pickup only. Shoot me an email.

Front heater available as well, email me.


Tripper
 
hey budy front fender just seeing how much and im still interseted in that top gimma a pm back
 
Some more parts shipped today. As I said, email is the best way to get a hold of me for these items.

Tons of stuff still around. Fenders are available as well as the top. Both are in rough shape but repairable. Any questions or requests please email me.

I don't have the amubulance door inspection cover that I'm aware of. The whole tub was pulled and trashed 15 years ago.

I'm not sure about the steering lock housing. I can take some pictures of the setup and perhaps you'll know.


I'm working on installing an Isuzu 3.9 diesel into one of my Patrols so getting rid of the old Cruiser parts will help speed the process.


Glove box door, speedo, ashtray and heater hoses SOLD
Title and VIN - PENDING

Lots available so chime in if you need something.


Chris
 
Wardfoto, use the email address and let me know what you are looking for. I'm assuming the emblems on the aprons.


madtripper @ deadspacesociety.com (take the spaces out for my address)




Chris
 
Headlights, buckets, adjustment rings and retaining rings SOLD and shipped

Door regulators - Pending


Still have a bunch including some larger items like roll bars, hood, doors complete less regulators and in ok shape. They could use the bottom skins but other than that, decent.
Frame still here, knobs on dash with controls, I believe all hinges, entire steering linkage, hard top (rough), rear jump seats....


Chris
 
I pulled the visors and rearview today. I have some interest in the bumper mounts, emblems, and wiper motor. Lots left and I've been selling at more than reasonable prices so get your lists together and let me know what you need.

Chris
 
Some other items I have pulled:

Radiator
Bib and bezel
Alternator
Hooker Super Competition Headers (Exhaust is still complete with mufflers, true duals all the way back)
F Engine @78K miles
Holley Carb and intake (somewhat rough but worked when pulled)
Roll Bar
 
Wiper assembly - SOLD
Rear Emblem - SOLD
Apron Emblems - Sold
Bumper brackets - SOLD
Grill Emblem - Pending
Door Regs - SOLD


Still a bunch left so make an offer.

Chris
 
How much for the doors...front doors that is? Ship to 99207
 
that tranny hump gone? is it in good condition not bad pitting/cuts from the po? can't quite tell from the pic

Shoot me an email. Hump was fine except some rot on one section. I can get better photos as needed but again, please email me.

Chris
 
Frame mounted body mount brackets? I need all 4 if you have means to get them off... and they are not trashed or rusty like this one is.

These are the ones I need... the mid-frame ones that look like:
 
Last edited:
Back
Top Bottom