1970 LC 350, 35's locked caged

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Well my FJ is for sale again, I have legal troubles based on stupidity and it's either sitting for quite some time or being sold. Specs as follows:

1970 fj40 salvage title due to engine fire

Body:
Hardtop with doors
Rollcage tied to frame at 4 points
Flat black paint job
Stinger style bumper w/radiator guard

Engine:
4 bolt 350 built
11:1 compression
World industries steel heads
M.T. valve covers
110 amp alternator
comp cam camshaft
Edelbrock aluminum waterpump and intake
Ramhorn manifolds
Msd Ignition w/ hei distributor
Jet Performance Q jet
4 core monte carlo radiator w/ taurus 2 speed fan
Optima Battery

Drivetrain:
SM465 w/ hydraulic clutch system
4 speed cruiser transfer case (rear output seal leaking, last guy who test drove it noticed it)
Rebuilt driveshafts (nothing square)
Twin sticked
Brand new bilstein shocks front and rear

Axles:
Sprung over on stock springs (w/ tration bar rear)
cross over steering
Bilstein shocks
4:10 gearing (street legal)
aussie lockers front and rear
mini truck disks and birfs w/ spare
hydro assist steering
Saginaw style power steering conversion
Crossover steering

Tires:
15 x 8 rockrawlers
35" mtrs on it now 80% (i'm keeping the 37's in the pics)
full size spares

Interior:
supra buckets (ugly but comfortable setup for 6'5")
Tilt camaro column w/ grant wheel
21 circuit ezwire harness
Full autometer gauges (speedo gauge needs a functional end put on it, as toyota doesn't match up)
red durabak interior
32 gallon fuel cell recesed 8" in floor
4 point harnesses
Toll cage tied in to frame at 4 points tied to body at 6

Exterior:
Angle iron sliders w/ chopped rails
Rear swing out carrier to hold a 37" tire hi lift and jerry can (now 35" tire)
Custom bumper w/ LED lighting
hard top and doors
Front stinger bumper and hoop w/ frame rails tied in

From the pictures, there will be no jerry can holder, no piaa lights and tires will be 35's at this price and the ammo can storage will be removed for my current project.

Street Legal and registered in Fresno,CA all turn signals, lights, whipers in working condition. 6500 P.M me for response or 559-999-0876 and leave a message. Pics can be emailed as well
cruiser front (640 x 480).webp
cruiser engine (640 x 480).webp
cruiser interior 1 (640 x 480).webp
 
up again

has the 35's on it now, transfer case was rebuilt and new clutch put in.

1.5" body lift was removed and center console redone because of this

I'm going to redo the cage tie ins in about 3 weeks (need my other vehicle out of the way) these need to be redone only because i removed the body lift.

It needs to go, i want to sell it to a cruiserhead not some guy on ebay.

If interested let me know

Will take money off if you have a tuff-shed or similar or 2000 vw jetta body parts (front end fenders, bumper, grille, fenders)
 

Users who are viewing this thread

Back
Top Bottom