100
- Thread starter KIRUXA
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
which schematic did you use for the drawer system?
No pistols for civilians in canada but you guys are rockin some cool wheels
Which ARB? Older one? Search "12v voltage cut-off"
Last edited:
The new ARB fridges have a built-in low voltage cut-off. 3 different voltage settings. It shuts the fridge off before killing the battery. The rear accessory plug is switched and will shut the fridge off when the ignition is off. This can be bypassed but it is recommended that you run new power cable at least 10 gauge for better performance.
Personally, I'd run 8 or 6 gauge back there.
Yes, I would set the voltage cut-off on HI with your standard lead acid battery, MED or LO with a deep cycle battery. The temp in the vehicle plays a large role on power consumption. So crack a window open and use sun shades when it's hot/sunny out.
Yes, I would set the voltage cut-off on HI with your standard lead acid battery, MED or LO with a deep cycle battery. The temp in the vehicle plays a large role on power consumption. So crack a window open and use sun shades when it's hot/sunny out.
^ This! Run both positive and negative wires to a separate/auxiliary/distribution fuse box in the back...then feed your appliances from there; fused accordingly. If you're like most of us then your electrical needs/wants will grow eventually beyond just the fridge...so go with a little larger capacity wire now to save time & $ later... 
I also incorporated a circuit breaker, sized just above my maximum draw for the rear fuse panel, in the engine bay near the + battery terminal where this leg runs from...
I also incorporated a circuit breaker, sized just above my maximum draw for the rear fuse panel, in the engine bay near the + battery terminal where this leg runs from...
Those are pretty cool! Not OEM I'm assuming... Where'd you pick those up?
Great looking truck, I like the clear turn signals a lot!
Might as well, I'm interested and would love to know where exactly you got them.
I like the way your roof rack turned out, my LC is the same color...I like the fact it's aero and has a front tray.
Do you mind sharing with me the specific model you ordered and options for that rack? I like that quite a bit, might just have to copy it
It looks like product code: KRTL003T
Do you mind sharing with me the specific model you ordered and options for that rack? I like that quite a bit, might just have to copy it
It looks like product code: KRTL003T
Dat camo
I like it! Adds a personal flare. Wouldn't look out of place down here in the South either
Yeah Nick started it, bake it at 275 for 7 minutes IIRC. He helped me (did it) install the HID retrofit. Thanks again Nick 
wow big project for the carpet; are you go with a new carpet or re use the old one??
....why wouldn't you do an HID install while you're in there? I need to open up my headlights again to cut back the top bezel to get back full range for my headlights. It's just super tight in there right now, and they're pointed way too low
Kiruxa, I was in Calgary this summer and drove the highway through Kelowna through Vancouver..
Know any reputable auto shops in Calgary?...I'll definitely return and I think the next time I go, I'll ship my LC from Texas and drive back...in fact, if you have any recommendations of shops, tire dealers, etc in Calgary, I'm interested...
Know any reputable auto shops in Calgary?...I'll definitely return and I think the next time I go, I'll ship my LC from Texas and drive back...in fact, if you have any recommendations of shops, tire dealers, etc in Calgary, I'm interested...