For Sale 100 Series Stoptech Front BIG Brake kit 355mm

[bjowett]

Vehicle Model

1. 100 Series
2. LX470

Stoptech front kit for 100 Series. Four piston silver caliper with floating rotors. Very light rust on one rotor from sitting unpackaged, will clean up before shipping. $1800 OBO.

 

[excessive]

very cool, never seen this kit before

 

[GTV]

Man, I wish there was a BBK for 17’s.

 

[bjowett]

These should fit under Rock Warriors, I can verify.

 

[GTV]

These should fit under Rock Warriors, I can verify.

My money is focused on other mods at the moment but if you can confirm they fit inside RW's that could really help your sale.

 

[vipergrhd]

Where did you get it,? My hundy is not ready for this I still have to swap the engine soon. Looks very nice, this would fit with the 18" rims?

 

[bjowett]

They came from a Stoptech supplier, and are not easy to come by at the moment. Replacements parts still are, fortunately. These should fit all 18”, and possibly some 17”.

 

[GTV]

355mm is roughly 14". General rule of thumb is the rotors are at least 4" smaller than the wheels but there are exceptions.

 

[bjowett]

The Rock Warrior 17” wheels have deep full diameter barrels, so they fit over the Tundra 354mm w/o issue. I suspect they will clear these, too. There are some nice low profile calipers out there (not these) that will squeeze a monster 360x36mm rotor under some 17s.

 

[Jim_Chow]

Stoptech front kit for 100 Series. Four piston silver caliper with floating rotors. Very light rust on one rotor from sitting unpackaged, will clean up before shipping. $1800 OBO.View attachment 3747949View attachment 3747950View attachment 3747951

Dumb question. Does one need to remove the caliper to install new pads? Is there a model # for the caliper brackets?

 

[bjowett]

Sold