- Joined
- Jan 4, 2014
- Threads
- 94
- Messages
- 3,024
- Location
- Little Rock, Arkansas
- Website
- www.facebook.com
Started making these tools to help you pull the CV of your 100 series as far outward as possible, allowing you to measure and install a properly sized snap ring. Had quite a lot of interest in the main 100 forum so I figured I'd post it here. The outer "support" bolts can leverage off of the hub flange studs or the alignment dimples on the flange itself (as seen in pics 3 & 4). $20 pickup or $25 shipped. Quick rundown of everything included:
- 6"16ga 14ga steel square tubing drilled & reamed on a manual mill, then primed & painted with black enamel
- (2x) 3/8-16 x 3" outer support bolts
- (2x) 3/8-16 hex nuts
- (1x) M8 x 1.25 x 50mm axle bolt
- (5x) flat washers
Here's a thread of mine on the recent disassembly & reassembly of my wheel bearings where I initially made this tool and gauged interest: Wheel Bearing Service w/Pics
Initial inspiration:
- 6"
- (2x) 3/8-16 x 3" outer support bolts
- (2x) 3/8-16 hex nuts
- (1x) M8 x 1.25 x 50mm axle bolt
- (5x) flat washers
Here's a thread of mine on the recent disassembly & reassembly of my wheel bearings where I initially made this tool and gauged interest: Wheel Bearing Service w/Pics
Initial inspiration:
Last edited: