torque spec

Hi - I don't have an FSM; wondering what the torque spec for these bolts are that adhere the third member to the front diff housing?

Hi All, Hoping someone on Mud has the Idler Pulley ft/lbs spec for the URJ200? Finishing up Tensioner/Serpentine/Idler Pulley/Checking in on the water pump. Thanks!

FJCO aluminum wheels, curious what lug nut torque spec the group recommends. Thanks!!

Anyone know the correct torque value to use when installing new hub studs? The cone washers and nuts are listed as 26 ft-lbs, but what about the studs themselves? I searched 'mud and turned up a lot of discussion of the nut torque value, and some other big studs (I'm omitting the name so...

Quick question. I am replacing my lower trunnion bearing studs with new OEM hardware. Plan is to install STUDS with red loctite. Any idea of the torque spec on the STUDS themselves? The original ones were not very tight. Should i just use red loctite and tighten down to a reasonable torque such...

I'm installing a Slee belly plate this weekend in preparation for Cruise Moab and thought I'd replace the tranny mount while i'm there. I've looked through the FSM, but could not find the torque specs for the 4 bolts anywhere.

My 1992 fj80 started idling very rough whenever in gear, to the point where I thought it was constantly going to stall when stopped at the stoplight. Figured I had a vacuum leak, and sure enough the pipe near the check valve of the air manifold was rusted and snapped in two. I pulled air pump...