steering

Any of y'all have a spare steering gearbox laying around that I could rent, while I send my leaky one off to West Texas? Also, I vaguely remember a couple more options for folks doing the rebuild...anyone remember?

This is a non used SMALL knuckle pattern double steering arm, 76-78 Land Cruiser. It was dirty from sitting around so I gave it a fresh coat of paint. $125.00 shipped Thanks, John

Did not end up needing in my build. $50 shipped CONUS

Has anyone done this lately? Mine is leaking pretty bad on my 77 even with the syrup thick Lucas fluid in it. If so, who sells the seals? I looked in the usual places with nothing listed.

Looking for some real time advice from Cruise Moab. Yesterday I discovered that the end of my ds steering boot had popped off and apparently puked out some fluid. The reservoir is full, there is NO active leaking, and the steering is fine with no odd behaviors. I reset the clamp and the end...

Driving home in my 77 a few days ago, it suddenly started to feel loose and start pulling slightly to the right. The steering wheel was perfectly centered before and now I need to keep it 5 degrees to the left to keep it going straight. I did a cursory glance underneath and all the linkages...

Hey All: Searched the forum and didn't come up with much regarding this topic. I have some bad clunk and a lot of play/binding in my steering column. I've been chasing this steering issue for a while, but I think I finally have it nailed down to the Steering column uJoint (Upper) and...

no tears or rips, in good shape. The front of it does have the shiny look to it. $175 shipped.

Steering wheel off my 1974 FJ40. Has minor cracks. Shipped to US address for $60. $50 SHIPPED!!!

So I got a '76FJ40 about 3 weeks ago. Since then I've changed all the fluids, Tie rods, Parking Brake, Fixed a crap load of electrical issues. Now I'm onto rebuilding the power steering since it is all wet down there. From this wonderful forum I know there is Saginaw, minitruck, ETC. However...

Used pickup power steering gearbox housing, free + shipping from 20912. I used the innards for a 40-series ps gearbox rebuild & didn't want to toss this out if someone could use it. There was some crud in the bottom (see pictures) but everything looked okay.

Very rare setup, this is a OEM FJ55 power steering setup from a 1976. I only have one of these due to it's scarcity. Comes with pump, gear box and misc lines although the lines are not guaranteed age can be seen/bought here 55 Series, OEM Power Steering Setup

I've been trying to get the steering of my '60 as tight as possible, given what it is. Several years ago, we had a rebuilt steering box installed and the results were okay. I was having clunking associated with turning in the front. Just got the truck back with new tie rod ends, which it...

Three years ago, I replaced my very leaky, original 1996 steering gear box with a reconditioned OEM replacement. Professionally installed. Cost me about $900 for parts & labor, but no more leaks. Everything was fine, until a few weeks ago when I had a 2.5" OME lift kit installed, along with 35"...

Just need to get rid of a few things, prices neg, just need a few bucks worth the trip to the post office. SOLD 1997 TLC steering wheel, oak, no cruise lever. Catskinz two tone leather cover. $SOLD Clockspring from 1997 TLC $20 Airbag from 1997 TLC, oak. Cover needs to be rivited back on. I...

I just cleaned up part of my garage and found my OEM steering wheel I replaced instead of refinishing it, so I figured I'd offer it up as a temporary donor wheel for anyone wanting to have their steering wheel refinished. It's free to anyone needing it temporarily (you just pay shipping both...

If anyone has any early steering wheels or steering wheel parts get in touch w/ me please . Thanks Jimmy

I swapped to hell fire knuckles. So I have the stockers. THey have new (but installed/removed) timken trunion bearings and both steering arms that INCLUDES THE OVERSEAS one for a front-side tie rod. I will ship them out for 200 to within the 48 states. OBO if its up for a while. REAR FULL...

Selling a nice pair of visors removed from an 86 FJ60 with gray interior. Includes the pieces that the visors clip into and the six mounting screws price $44 for the pair. Also have a nice gray clamshell price $35. Buyer pays shipping. Best to email me shmukter@pa.metrocast.net

Anyone ever replaced these hoses with regular hose to avoid relating evite system? If so, what size?