steering knuckle

Is it possible to replace the steering knuckle oil seals without disassembling the steering knuckle and axle shaft?

I have a 1990 HZJ80 and this is my first time attempting to rebuild the steering knuckle on the left side, which has the longer axle. I replaced the CV joint, mounted it on the axle, and secured it with the snap ring. After greasing everything, I reassembled the hub. Before installing the...

Urgently looking for LH steering knuckle Part # 43202-60020 Used/new/junkyard Seattle, Wa If you know any junkyards with a 100 series please let me know- I would greatly appreciate it Thanks

Hi All, I have super fat tyres on my 1976 FJ40. The rubber washer on the steering knuckle is precariously close to the inner rim of the wheel hub. It just about touches it. I am considering installing 5mm spacers but then I will need to remove the wheel studs and extend them for longer ones...

Hello all, Recently bought a 2007 LC, attempting to get to a baseline maintenance wise with her. First thing on my checklist was the drivers wheel bearing, did lots of research and attempted several times without success as my bc axle will not come out far enough to even get the thinnest snap...

So while things are open for my brake system refresh, might as well do the Knuckles for this 20-year old car. Then I can close it up and call it done for my Front End Baselining (already did the CV Axles one year ago).

This is on a 2002 LC with 230k miles. Looks like nothing in the area has ever been disturbed. The tie rod / steering knuckle area is soaked in PB blaster. I put the tie rod puller on and turned it as tight as I could do with a wrench. Didn't come off so I then drilled the puller bolt in with my...

Hi Everyone- first off this forum is awesome. Helped me prep in buying my first (1994) lancruiser and I’m so stoked to get this thing built! First of all, my Steering knuckles need serious resealing. Considering how much has to be taken apart at the front wheels does anyone have any...

OK, I did a search and possibly I am missing something. I have the factory service manual and it fails to state how much Molybednum disulfide lithium base chassis grease (NLGI No. 2) to put into the knuckle. I was believing that you don't fill it to the top...and squirting it with a grease...