replaced

  1. F

    Replaced A/C resistor. Still not blowing on Setting #3 afterwards.

    Hello everyone, I just replaced the resistor on my 1992 today. Before that, the 3rd A/C setting wasn't blowing and I read that replacing the resistor would get it back. Well after replacing the resistor, I'm still stuck in the same boat with no #3 setting. The first two and the last settings...
  2. R

    Replaced tilt/tele module key fob dead

    99 LX470. I recently purchased this LX470, the tilt tele is really dead, not a peep from any of the motors. Was informed that there's a module that controls this and replacement might bring it back to life. Well I did, didn't fix it but key fob doesn't work anymore. Had to dc the connectors on...
  3. mark71

    Cowl part# help please, for the passenger foot well leak

    My 2008 has the footwell leak. My weather-strip fix only worked for a while and I'm finally ready to give in and get the replacement cowl. There are numerous different part numbers quoted in the various posts. Part # 55708-60091 is much cheaper than 55708-60101. I've seen conflicting...
  4. 4runnermods

    After 10 years owning a 5th gen, Parts replaced.

    After 10 years owning a 5th gen I found a series of OEM parts that commonly fail on several 5th gens. My truck has 225k miles SR5 premium. Some are pretty stupid stuff. Because I park my truck outside and it is exposed to all weathers, after 6-7 years I replaced all the window weather strips...
  5. C

    2002 LX470 CV Axel replaced and vibration started.

    Hello everyone, I took my 2002 LX470 to the shop last week to replace the CV axles as they were worn-out. After replacing with TRAKMOTIVE from Rockauto.com, a strong vibration started. The shop mounted NAPA ones, same thing, rebuild and balanced the front shaft, still there. Removed the...
  6. H

    AHC Removed and not replaced

    Hiya, owner says the mechanic removed the AHC, and just let the springs do their thing. is this OK ? Seems a bit strange. We are going to look at the vehicle wednesday. I will drive it in all modes, down some bumpy roads, any advice on what to look ( listen/feel) for ? TIA. Hope it works out...
  7. G

    Can a cracked upper thermostat housing be replaced?

    1988 fj62. Appears to have small crack below engine temperature switch and is weeping coolant. Used upper housings seem crazy expensive. Anyone know if there’s a decent way to repair the crack?
  8. WoodyCreature

    Warn M12 replaced for ComeUp Seal 12.5 in an ARB Deluxe bar

    Quick write up about swapping winches. There's seems to be some misinformation out there that you have to pull the ARB bumper in order to remove the massive Warn M 12,000. This is not true, and it can be done by one person. The biggest hurdle seemed to be figuring out how to remove the vertical...
  9. onpoint01

    Replaced rear upper and lower gate

    With the front end looking so nice after my previous post, couldn’t deal with the rust on the rear gates. I’m amazed that you can still purchase new Toyota sheet metal. Will be leaving the badging off as well as the wind deflector. Easier to keep it clean without the badging and don’t want to...
  10. samwise

    3b won’t shut down after alternator replaced.

    I replaced my alternator with a spare yesterday while trying to figure out some other problems (my other recent post about blinkers causing the edic to shut the engine down details this) but I thought post a sep post about this. This didn’t fix my shut down problems either. after the alternator...
  11. D

    Do these heater t’s look replaced?

    Recently purchased an 07 and am doing some baselining on it but am leaving for a trip this weekend and the heater t stories have me a little nervous. The truck has 125k on it and at 100k the PO did the timing belt service as well as a bunch of other things (radiator hoses, thermostat, water...
Back
Top Bottom