r150f

good evening lads been thinking about planning a supercharger on the 3RZ and that brings up the question on beefing up the transmission and everything in between if toyoDIY is right then my rig(rj77) came with the G52 which probably will shatter if i add any boost to the engine searching around...

My 1985 4Runner. 1UZ swap. Advance Adapters RF1A case to R150f adapter. The transfer case shift rail hits the tailshaft housing - see photos. Has anyone run into this issue? Can I just notch that section out to clear the transfer case shift rail?

For sale is a 2012 R150F 5 speed transmission and transfer case. Came out of a 2022 Prado with 5LE. Has the electronics on it (see pics). This only has 40km on it. You'll need a bellhousing as I needed the bellhousing to mate a different tranny on my 5LE engine. $1500.00

Hey yall, Im swapping a R150f into my v8 04 4runner. Reason im doing this is because i hydrolocked my engine, so i have to swap it out, and i was able to get a r150f from an 88 v6 pickup with 90k for pretty cheap with the tcase on it(already have an fj case, but they should both be chain driven)...

I have a 2LT-E that I'm going to swap into my VZN-110 with a 3VZ-E. I've got the engine in the back of my other truck, an ECM and wiring harness on its way from N.Z., and I'm still looking for a Bell housing for my R150f transmission, and a relay setup. What other stuff should I be getting...

Now Live on Bring a Trailer Auctions 1991 Toyota Land Cruiser LJ77 LX •Left Hand Drive •Factory Brown/Beige Metallic Paint •Factory Brown Cloth Interior •194k kms Documented •2LT 2.4L 4cyl Turbo Diesel Motor •R150 5 Speed Manual Transmission •2 Speed Transfer Case •Electronically Activated...

disclaimer - i have read dozens and dozens of threads on these topics, but still havent quite found the answer. thanks to Beno, 70's guy, toolsrus, tor, romer, and many more for lots of ideas, info and knowledge. BLUF: i am wanting to pursue a v8 conversion with 5 speed manual transmission, as...

The A340F A/T in my KZN-185 is on the fritz, so I am thinking of doing a manual swap. There are a lot of write-ups for doing that on a 3rd gen 4runner, but I haven't yet found anything comprehensive for doing this on a Surf. The first, threshold question I am trying to figure out is can I mate...