hi guys looks like there are more choices for glow plugs any advances to running the CERAMIC Type?
OEM part number 19850-64031
DENSO part number: DG-649
BOSCH GLOW PLUG (NOT-CERAMIC)
Bosch Glow Plug - GPT-220
BOSCH GLOW PLUG (CERAMIC)
Bosch Glow Plug - 0250202095
NGK Glow Plug - Y744M
Greetings all.
The glow plug light on the dash doesnt turn off (KZN 130 1995)
I have replaced the glow plug timer and when checking with a multimeter, there is no voltage across the glow plugs... but the light stays on.
Any advice on how to troubleshoot where the problem is?
cheers.
I picked up the appropriate plug for my alternator from @Coolerman and have a yellow and black/yellow wire now.
But, no idea what wires they connect to on the 74 harness. Diagram says W, WG, WB but no wires like that near PS fender.
By the igniter I have a BY and a B wire. ??
By the charcoal...
Reinstalled the oil pan last spring and basically parked the truck. Been driving it a bit and it started to leak. replaced the crush washer and leaks just sitting there. Im talking puddles not a drop or two. Would O-rings help? Double up the washer?? Looking for ideas..
Thanks, Jim
I have revised this to discuss all clusters series to help with Tach identification. Later versions have ABS and/or Diff lock lights and other idiot lights on dash but main elements all work. The instrument clusters (aka combination meters) are solid state boards that are difficult to add or...
Changing out my spark plugs and wires. It's always the last one right and so happens to be #6.
The Spark plug itself is in #6 with the broken off rubber from the boot still around the plug. I can not get the 16mm deep socket or a 5/8 around the plug itself to remove the plug. . I can feel the...
We moved the gas tank from beneath the passenger seats to under the bed. Now we have a hole there. They make a gasket for the fuel lines, but need a plug instead.
After enduring too much trouble with my original superglow timer which frequently did not operate correctly I decided to use my electrical engineering knowledge to make a timer replacement.
This board is based on an ATMEGA328P for the logic part.
Current features support:
- Water temperature...
I'm looking for resources on how to change/replace my 2014 LX 570 spark plugs. I have found some YouTube videos on the actual unscrew/removal of the spark plugs and install them. However, I'm looking for the part that's before the actual removing and installing of the plugs itself. I need to...
How do you get these dang things out? I've broken the plastic (or hardened rubber) inner rings, some were already broken. I've bent the tabs up from inside the valve covers. I'm trying to wedge a small flat head under the seals, and can't get a grip on them with needle nose pliers. What's the...
I drained my tank in my FJ40. The rubber gasket is intact on the bottom of the tank (I left it in place, since it didn’t come off with the plug). Is the any sealant I can/should use on the plug when i reinstall it to ensure I don’t have leaks? Is anything recommended or useful?
Thanks!
i was hoping to get a better understanding of these two issues. does anyone have any pics or technical information?
do i find both of them in the FSM in the mechanical chapter?
do spark plug tube seals get done when you do a valve stem seals get done when you do a head gasket?
i've got a couple...
I added a sub to my 07 with Mark Levinson. I used the rear channels and used an Audio Control LC2i. This allowed me to add a sub/amp to my factory system.
My search-fu is weak. Does anyone have the thread size and pitch for the A440F drain plug on a 1991 FJ80?
Please berate me if it exists somewhere. But also please drop the link.
I am looking for a harness plug from a 91-92 80 Series. The plug I need is the female side from the engine harness that plugs into the dash harness near the ecu. I have attached a picture of what I am looking for with a red circle around the plug needed. I would like to have at least 6 inches of...
Yesterday I was having some issues starting my 60. Disconnected the terminals and cleaned up all the connections I could. While doing so the double eyelet for the fusible link feel apart from corrosion. While messing around with that I noticed that the large black wire (small black FL wire)...
We are on a three week family roadtrip and very sadly, a sparkplug on our 2010 Land Cruiser seems to have blown out and stripped all the threads in the hole. New sparkplug doesn't go in, just rattles around in there.
Local Toyota Dealership is saying a new engine is likely required, but is...
looking 4 one of these plugs that goes to dome lights... I know they were used on multiple Toyota’s during this time period.
and why no part number? come on!
conntinued on next post becuase image limits....