plug

My 83' BJ42 doesn't start well unless its warm weather. I notice that the glow plug light stays on for the about 2-3 seconds if its 30 or 80 degrees. When it does finally start up it blows plenty of white smoke for about 15 seconds. Would this be the glow plug timer causing this problem? Thanks

Im on the process of replacing the valve cover spark plug seals and I noticed I have scored the seal surface in a few areas. Should I be concerned? I forgot to take a picture before I dropped it off at the machine shop to get cleaned (im doing a head gasket) . I was thinking maybe a thin rtv...

I need some help identifying the plug that fits into the AC compressor plug. I have an 1985 24v HJ60, so not too sure if it is different then the Fj60's compressor plug. Here are a few photos of the plug (with the blue and white tape) I'm referring to. And a close up of the connection...

Found this as I was doing some electrical work. Don't know how long the wire has been loose (I unplugged the relay for picture only). Just need to know which one it came out of. Thanks in advance.

Hey guys. Im ditching my malfunctioning superglow system and I built a simple relay-on-a-momentary-switch manual system. I live in Southern California so I wont need this every day, but I spend enough time in the mountains that I do need reliable glowplugs. I cant seem to find a true 12v plug...

If anyone has any electrical experience on these old 2L-T wiring harnesses I would love to hear from them. I have swapped in a 2L-TII into an 1989 LJ70, and the harnesses and glow plug rails are a bit different. If anyone has any experience, with the 2L electrical system I would appreciate any...

Hello all Needing a bit of help with my glow plug system on my 1980 HJ45...Currently runs and drives but only by a using a ghetto Wilson switch if you can even call it that. The way the PO had it was to basically warm up the plugs directly with the battery. also using a direct wire to...

Wondering if it's common practice to use a new oil plug gasket every oil change? (FJ40) I don't on any of my other vehicles but now my 40 is marking his territory again and is subject to banishment by the queen!

Can anyone provide the part number for the plug with 2 prongs in the wiring harness that plugs into the motor. It provides power/signal to the motor telling it to go up or down. It is the male side that plugs in here. Looked at the common male plug sheet and could not find a part number.

Good Morning every one While preparing the 1Fblock to sand and paint I decided to remove the coolant plug and while inspection, it looks like the tip of the threaded end broke off and I don't know what to do and it looks like is pluged with rust. My question is if I drilled it out and tap it...

Mine disintegrated. Does anyone know where I can get a replacement? Thanks.

ok so I have a 1984 BJ60 from Canada... the glow relay clicks on and off in he same second it starts .... the glow plugs get power with a test light and turn off... so I need to figure out what to Ck or replace nexted ... it's really slow to start and I'm sure it's the lack of glow ... any help...

im changing the the diff fluid and wonder if anyone knows a part number at Oreillys or Advanced that will work for new drain and fill plugs? Meaning another vehicle that has the same plug that will work. I started the job and would order from Wits End but in a time crunch. Thanks !

Running a momentary switch using the stock main relay and the 23 volt denso plugs for a 24 volt BJ 70. I ran a 10 gauge wire from the relay straight to the plugs as that is what the factory wire size looked like. But now I am wondering if that is large enough?? Was hoping to find the amperage...

Trying to put everything back together after a head gasket replacement. The wiring harness and all the emissions stuff are giving us fits. #1 right now is this very large female plug. We can't seem to find its male counterpart anywhere under the hood. Does anyone know? Thanks very much if you...

This is connecting to the positive terminal. Previous owner had a 30 amp fuse lined inbetween thisnand the battery and a flat blade connector siliconed in. If so where can I get a replacement connector (junkyard is my guess? Previous owner fxxxed with interior wiring so much I'm getting ready...

Hey by any chance would any local folks out there have a used set of plug wires you'd be willing to let go on the cheap.. Trying to fix up a non running 93 FZJ80 and I don't want to drop a bunch of money on a truck that I have no idea if it even runs in the first place.. Once\If I get it running...

Two things that I am not sure of what they are: 1-I think this is a plug for an OEM CD changer? If it is for the CD changer I will re purpose it to power an inverter or? 2- I found this little foam stick floating in my windshield washer reservoir. WTF is the purpose of this? Never seen one in...

I was doing my oil change and I couldn't get the copper washer off the drain plug, the person that did the last oil change torqued it wayyyy too high. I ended up using another drain plug that I had laying around, it was a little longer than the one I took off but it fit regardless. I used this...

The grease plug that fills the end of the front drive shaft is missing from my truck and I'd like to replace it. This is the plug that protects the driveshaft slip joint from water and dirt and also lets you grease the slip joint using the grease zerk. Without the plug, grease pumped into the...