help

Hey y’all, hope everyone is good on this fine Oct day. So I have a misfire that has me stumped, I’ve chewed through every misfire post mostly on here and even some others with vehicles that share my engine (2uz in a 2000 lx470). I’ve got a rough idle, regular throwing of a p0304. Weirdly it...

Having some issues trying to get my heat to adjust from cold to hot and vice versa. If I pop the hood, i can open and close the valve manually to obtain heat or cold, so in the summer I close it and the winter I open it, so I know the valve isn't the problem. If i disconnect that cable at both...

Hey everyone, Ive been looking all around for some information on where this oil leak im dealing with could possibly be from and cant find anything so im turning to you all for some help. Recently my 1994 81 series with a 1hdt has started to develop a oil leak and it appears to be spitting oil...

I would like to replace the whole assembly not just the motor. I’m have a heck of time identifying the correct part. Is the LF and LR the same assembly? Any advice or guidance would be appreciated

My fzj80 isn't running smoothly, slight misfire, ticking from the front/top of the engine. No CEL (sadly) and it runs okay. When the engine is cold, and I first start it up it runs absolutely amazing, no ticking, not misfire, no shaking. Once it warms up and starts reading the sensors it runs...

This comes about because the dash speedometer in a 1979 FJ45 does not work… the cable runs from The Transmission straight through to the back of the speedometer. I have not investigated it further yet by removing the cable from the transmission and see if the cable is intact. I also remember...

Moving my TJM over to new rig. I didn’t do the original install. Anyone got a pic on how to trim this driver side air guide? The original installer apparently couldn’t figure it out either as the whole thing is just missing on my 2013.

Hey everyone I’ve been helping a friend repair a broken birfield on his 1994 land cruiser. I’m new to working on solid axle Toyotas coming from a ACVW background I’ve been learning a lot but this is my first time doing a birfield. I’ve gotten everything buttoned up but I went to put the outer c...

Hopefully a quick question, my 84 FJ60 has high CO‘s at high idle test. I’ve rebuilt the carb, adjusted the valves and timing repaired the AI system, new plugs, wire, cap and rotor, verified no intake leaks. Adjusted the carb while on the sniffer. I was able to get HC’s and CO’s in spec at idle...

We did a Radiator Replacement I have a outlet Pipe leak on the pipe to the Engine block. It is a car passed down from a friend who passed during Co-vid and we are trying to get it back up and running as a nod to him. Is there any sources in the US to get parts?

Hey everyone, I'm new to the forum, the rules said I had to post an introduction, so here I am. Howdy. I've got a question pertaining to the alternator/regulator of an FJ40 I'm doing some electrical work on. This thing has had many owners and the wiring has been modified a bit by other...

2007 LC 265,000 miles replaced upper and lower control arms, wheel bearings, one axle in the last two years. Steering rack was replaced about 5 years ago. Slight sensor lift on 34" tires. Every so often and more recently when I turn the truck left (like making a left onto a side street) the...

Does anybody know where this brass elbow hose is supposed to go to?

120k 2014 GX460 all stock. Over the last 20k miles I have developed what I personally know as "Toyota truck s***ty front end syndrome". I don't know if there really is a universal syndrome, but I do know that I have observed similar symptoms on various 4runners, Tacomas, and now my GX. It...

I screwed up. Rebuilding my 83 FJ40 carb and didn't record the numbers on the long slow jets. One is #65 & other is #90. Need to know which is Primary and which is Secondary. Don't know if it matters but I'm at 5000' elevation. Thanks, Jim

Looking to obtain a VIN from a new 2022/2023 Prado 150 VX Matte Black edition. Really just need it for parts verification. None of the overseas sites post vins like they do here. GCC because left hand drive and can make sure headlight part #are correct for use here.

Just paid what is probably a record high to get my trans rebuilt, the genius forgot to torque the drain plug back so it fell out somewhere on the highway and I drove the gx a couple miles while it leaked all over the place. When I finally parked and turned it off is when it really started...

Hello all. Continuing in my 80 series resto- Have codes 25, 26, and 71. Running lean, running rich, and EGR System. It’s worth noting the vehicle is running fine over all- no noticeable issues. Any advice on where to start?

Yesterday we took the Landcruiser out for about a 150 mile round trip through some elevations. When we got home and off the highway at a light the oil pressure as read by the gauge dropped to a seriously low level and the car started vibrating a bit at idle. By seriously low I mean there was...

I’m just about to paint the FJ 40 and I have the transmission tunnel off and I noticed that my transmission and transfer case linkages do not match the holes on my cover. Any help would be appreciated