fuel

1997 Land Cruiser.........298K miles, original injectors. Pretty sure I've got one injector (possibly more) not atomizing the fuel. I am going to either replace all of them or have the originals serviced. My choices: 1. Buy all new injectors (Denso). 2. Have all original injectors, cleaned...

Let me first say that my newly acquired 80 was running like a three legged pig from the get go. I've been slowly doing some tune up maintenance/repairs when the weather allows. I got to the point where it seemed like some of these tune-up items were paying off (fuel filter, air filter, oil and...

What sort of fuel tank prep did you perform for your gas to diesel conversions? Did you go with a new tank or clean/prep your old tank?

I've tried to find old threads with similar issue no luck. At first I thought the fuel gauge was off but after running out of gas couple times I was only able to pack 20 gallons of fuel in. When the low light comes on I can usually pack 18 gallons in. Looking at the tank it looks OEM, I'm...

Hey there. Was hoping someone could shed some light on what's wrong with my whacky canukee (bj60). Installed an aftermarket sedimenter or water seperator. Tore out the old one. Primed everything. Truck runs for 10-15 minutes fine and then dies. Whenever i check the bleeder it has has in it...

I am looking for a used and reasonably priced confier style tank for my fj40. I would prefer a local pick up situation somewhere in the PNW area or northern california.

I have a new in box FRB5-1 for sale - many guys run these in their 40's and they have great salt and spray resistance Specs are hereWalbro FRB-5 Industrial Fuel Pump from Fuel-Pumps.net Comes with optional check valve and extra filter and O ring. $120 Shipped CONUS

Hey there, Dropped the fuel tank down today as part of my slow paced project on my 1985 FJ60. Short story is that it was sitting for 14 years or so in a garage. Got the carb rebuilt by Mark, drained gas, new fuel filter and now I'd like the opinions of the seasoned FJ60 guys. Oh and the fuel...

My truck was running great, but I took it on a drive and it seemed to have lost all power between idle and boost. If you punch the accelerator it will do absolutely nothing for up to 5 seconds and then start to gain power. once its revved up in runs fine (maybe just a bit less power than usual)...

I've searched but can't find how to jumper the fuel pump with the vehicle not running. I want to pressurize the system to check for potential fuel leaks. Thanks!

I decided to replace my oem Fuel Pressure Regulator with a new Napa Echelin FPR. The parts are pretty much identical. So I got it all in place easy enough, put the original brass tab washers that you see in the picture back on and tightened the banjo bolt. I start the Cruiser ('91 3FE) and gas...

Hi Everyone, So after ASTR killed my dreams of fitting an Isuzu 4HE1-T into my FJ45 (thanks to ASTR for working it out, so I didn't have to), I've been looking for a diesel to drop into it. I was really hoping to use an old mechanical 4 cylinder diesel like the 14B-T or 15B-FT but it seems that...

Hey guys So im the proud owner of a 12v 1982 bj42. For the last 4 months or so ive been having a few issues with it. Ive tried multiple times to fox it and everytime i think i have but then 2 weeks later the gremlin is back. So whats happening is basically it wont idle smoothly. As if its on 3...

Hey guys So im the proud owner of a 12v 1982 bj42. For the last 4 months or so ive been having a few issues with it. Ive tried multiple times to fox it and everytime i think i have but then 2 weeks later the gremlin is back. So whats happening is basically it wont idle smoothly. As if its on 3...

So I have been at this for about a month now. Engine was running fine before and after replacement of valve cover gasket. About the third time starting up to move the truck the motor started running awful, white smoke and fuel leaking from the exhaust manifold to the point it puddles up on the...

Hi All I need to make a few gaskets to seal the sender and inspection plate. it's a galvanised aftermarket fuel tank and the surface where the sender fits is a bit warped, so i need a thick soft gasket here, What is the correct material to ask for please. It need not be bio diesel compatable...

I need a fuel filler neck, hose and filler door for my 1979 FJ40 restoration project. Thanks

I need a fuel filler neck, hose and filler door for my 1979 FJ40 restoration project. Thanks

Needhelp people Did look around this forum , and try few tricks but only helped for awhile This is 1987 Toyota Troopy 3,4 3b with 270.000 km on the clock Got it 10 monts ago, truck was running fine, did simple maintnance ,fresh oil, new filters, replace all gear oil, front back axles, TC,gear...

Hey Guys, I recently had my truck engine swapped and re-sealed by Ryan Baxom out of Warrenton, Va. He did a great job and I was pleased with the work. I picked up the truck in January and drove it with a buddy down to Nashville (my new home). About 2 hours outside of Nashville, right after...