Hey there. Was hoping someone could shed some light on what's wrong with my whacky canukee (bj60).
Installed an aftermarket sedimenter or water seperator. Tore out the old one.
Primed everything. Truck runs for 10-15 minutes fine and then dies.
Whenever i check the bleeder it has has in it again. So i keep priming hiping the air will be gone and again and again the,truck stops running after the same amount of time?
Fuel feed pump faulty? Probably not as the truck will run on its own right?
Could it be something at the fuel trank side?
Appreciate any assistance.
Installed an aftermarket sedimenter or water seperator. Tore out the old one.
Primed everything. Truck runs for 10-15 minutes fine and then dies.
Whenever i check the bleeder it has has in it again. So i keep priming hiping the air will be gone and again and again the,truck stops running after the same amount of time?
Fuel feed pump faulty? Probably not as the truck will run on its own right?
Could it be something at the fuel trank side?
Appreciate any assistance.