Hey yall , my wife and I have recently purchased a RHD 100 series landcruiser to replace our old 80 series that rusted out. The vehicle didn't come with floor mats so I'm wondering if anyone knows of where to get ahold of any direct fit floor mats. I would prefer rubber all weather mats. Finding...
Does anyone know what the insulating ‘mat’ on the underside of the floor pan (passenger side in Australia and up into the transmission tunnel) is called? Mine is sagging and missing some clips. Trying to find it on partsouq etc so I can figure out what I’m missing?
I was looking at different materials could be used as a floor mat for the tub.
I looked at the .5" horse stall mat.
Wondering what everyone else has used for this - if at all.
FJ40 gas tank well floor pan. Great condition, original steel. Was planning to use for a project I sold. No idea what its worth. $125 OBO + shipping. Thanks
Any tips for replacing the rear sill and floor on a '78 FJ40?
I am shopping for a replacement and wonder about the quality of replacement parts out there.
Thanks, Ken RN
Looking for thoughts on best way to address this. It is surprising to me that there is nobody making repair sections for a 60, as many of them as there is out there! I have posted in the classifieds looking for someone who might have a solid piece on a parts rig, not sure what else to do?
Just thought I'd post this up since there are always posts regarding treating rust and with some are paying top dollar for "rust free" 100's, or anyone looking to preserve their's.
I recently acquired a "rust free" southern '99 LX. I have been going thru it to clean it up and pulled the...
Looking for the floor pan sheet metal that goes under the gas tank. Also looking for windshield wiper motor brass tube, windshield wiper arms, dash board metal from the passenger side and seatbelts to start. Located in NW Louisiana
My passenger seat stopped sliding back, a while back (still goes fwd). Today I found this cap on the floor. If I'm not mistaken, this has something to do with the seat fwd/back function. If that's true, can this be reinstalled or do I need a new one?
On my newly acquired FJ62, the brake pedal goes pretty much straight to the floor and there is almost no stopping power. With the car off, the pedal is pretty firm, but as soon as you start the car, the pedal goes to the floor.
I bled the brakes twice using the old fashioned (pump, pump, hold)...