cb antenna

Hey guys, I have a 1991 fj80 and I just installed a uniden CMX 760 CB and a Rago fab antenna mount topped with a 3' firestik antenna. It is mounted just above the passenger side tail light. I have tested continuity and everything seems fine, but i have an SWR reading of 2.5-3.5. I've done a...

Hey there selling my CB radio SetUp pictured bellow. Available for local pick up in Oceanside, San Diego. Both items are like new and selling as a kit asking $70.00 Message me if interested. UnidenPro505XL by BlueSteelGX470 posted Jun 9, 2018 at 1:35 PM Wilson Trucker 200 CB Antenna with 5in...

Hey guys. I put together an Amazon list for stuff I need to put a CB in my truck. Can you all go look at it and tell me if I'm missing anything? You can critique what I have on there a little, but please only for performance reasons. Not something like "I'll never use this because only...

I'm dropping this thread in here just for anyone else who may have this problem. It's old news to anyone who's had this problem and it makes sense when you lay it out, but I spent a good couple of hours messing around with things before I figured out the obvious. I have a background in RF...

Curious about this one. There's a mount down the lower bumper (big piece) which would allow the spring to flex and bend the antenna back. The higher mount (pictured) doesn't really do much for front-to-back impacts (the typical problem). Any feedback or ideas on this? Probably will put the...

Not a really big thing but I keep losing the cap on the 3' tuneable Firestik antenna when we have been offroading the last 3 times. I have it mounted on the Bandi mount and I am assuming that it snags on a tree branch and falls of. Should I crazy glue it & maybe cut off cap if I need to...

Hey folks. Wondering if anyone has some wisdom to share: I just finished installing a CB radio system in my LX470. I've got a Cobra 75WXST and a 3' Wilson FGT-3 fiberglass antenna mounted on the rear ds corner via a LabRak style mount bolted into the lift gate bumper, and connected via an...

Here is a antenna mount I built for my GX 470 using a framing bracket I found in my local Home Depot isle. It was made from a flat angle bracket. Part# may be in pic stamped into the metal. I made measurements and precision bends. The nice part is it bolts under the existing door bracket in...