brass

  1. cppilot

    SOLD  Hand Crafted FJ40/45 key chain

    I have one of my hand crafted solid brass key chains up for grabs. $25 free shipping. Shoot me a pm if interested. Mark
  2. dmamj

    SOLD  Vintage TOYOTA MOTOR Brass Bar

    This brass bar was available for purchase from Toyota directly as part of their "Standard Tool" set beginning in the very early 70s, if not sooner. You could purchase it separately as well, but guessing not too many made their way into Toyota enthusiasts' tool boxes back then. It wasn't included...
  3. T

    Wanted  Buffalo, NY: FJ40 early wiper motor brass tube

    Anyone have one or two of these? I know the thread is super hard to find so not sure I can duplicate. Part is the brass tube that carries the output shaft on early 40 wiper motors. Someone cut one short
  4. veiloctane

    BRASS FUEL CUT OFF PIN VE PUMP

    been creeping the dodge 12v Cummins forums and came across this part anyone use something similar on our toyotas 1HD-t perhaps? apperentaly the factory rubber tip can break off in pieces wear off and prevent you from shutting off the engine.
  5. Eurasiaoverland

    FJ62 pressure port brass seats

    I'm rebuilding my 1989 steering box (BJ60 but basically a RHD version of the FJ62 box). I have all the seals/O rings/teflon rings etc except the pressure port seats. Looking globally, (things might be different in the US), three different parts were used for the seats: Early 60 Series (80-83)...
  6. E

    Help with Supercharger brass elbow hose location

    Does anybody know where this brass elbow hose is supposed to go to?
  7. cppilot

    SOLD  Southern Oregon: FJ40/45 Hand Crafted Solid Brass Key Chain

    Hand Made FJ40/45 key chain up for grabs. Each one I make is a little different. $25 includes free shipping.
  8. cppilot

    SOLD  Southern Oregon: Hand crafted FJ40/45 brass key chain

    I have this hand crafted FJ40/45 key chain thats looking for a home.😀 $25 includes free shipping
  9. alia176

    Tour of NM metals

    For the DIYer among us this place has lots of metal, alum and brass. They can also bend, sheer and dimple the crap out of anything 😁
Back
Top Bottom