brake

I have this on going issue with my parking brakes. I adjusted the parking brake pads at least 4 times but it didn't solve the problem. Finally I even lower the adjustment screw all the way down on both sides. Still whenever I disengage the parking brakes and I am about to drive, the rear wheel...

I was on the highway at about midnight and felt my brakes go to the floor as i was getting off the highway. I could still stop it by going to the floor. I pulled into a parking lot and saw smoke (probably brake fluid that came off the exhaust) and saw that one of my brake lines in the rear went...

Can anyone give the bolt size that one would use to free the brake drum? Looks like my wheel cylinder leaked and I believe the brake lining swelled. This drum is really stuck. Any help and suggestions are truly appreciated.

No rust, some minor damage to lower lip $50 plus shipping

Anyone out there have an idea if I could put a Tundra right rear e brake cable assembly (Part # 46420-0C061) on my Sequoia (right rear e brake cable assy part no. 46420-0C080)? My e brake is seized and the Sequoia cable is backordered with no availability until the end of Nov. This is for a...

Whatever doesn’t sell is getting scrapped at the end of the week Have: 1975-90 40/60/70 - 3 pairs 91-92 FJ80 front - 1 pair 93-97 FZJ80 front - 3 pairs 93-97 FZJ80 rear - 3 pairs $35/pair shipped US. That’s $11/pair + USPS large flat rate box

I have a large crack in my third brake light and need to replace the whole unit to stop water getting into my tailgate. Looking for one to replace mine. I have a 2000.. assume all 100 series are the same part.

This is driving me nuts. My passenger (R) brake light keeps burning out. But just the brake filament. The running light filament in the bulb is fine. I've tested voltage at both circuits coming in to the bulb and measure 11.4 - 11.6 V with ignition off and 11.6 - 11.7 V with the engine...

I have 4 15” steel disc brake (welded)wheels. They have 33”x9.5”x15” BFG All Terrain tires on them. The wheels have hubcap clips and are clean. Tires are very old but are good for project rollers. Picture of date code attached. $450. Pick up only.

I recently bled the brakes in my 1988 FJ62 (first time), and one of the rear brake bleeding nipples - the driver side rear) was different from the other 3! It’s shiny, and new, and not covered in grease and dirt like the other 3. It takes a 10mm wrench like the other three, and it is functional...

I have a leaking cylinder on my ’71 FJ40. I’ve looked for replacements but not a lot of luck yet. Anyone with some sources would be appreciated. I pulled the wheel off the Cruiser today and it looks like the right side cylinder is leaking ( what do y’all think? ) Is it possible or an option to...

Hi all, I was picking up a bunch of passengers in the rain last night put the parking brake on to load everything up and then drove off. I went about three city blocks (less than 1/2 mile, maybe 25mph max) before I realized. A couple stop signs and a hill but didn't even notice until I saw the...

Hello all, I changed my brake pads and front calipers, and took that opportunity to bleed the brake system. It all went well until the last one.. The front driver side (which had the seized caliper in the first place) brake was very slow going when attempting to bleed, and there was some black...

For sale used Advics brake master cylinder BMT-061, 3,000 miles roughly. Changed brake setup. $40 plus shipping

These came off my 60 this past spring. They have roughly 3,000 miles on them and are the 4runner brake upgrade, has OEM Toyota reman 1995 4runner calipers loaded, and new FJ60 brake rotors. All Factory Toyota parts. These brakes worked VERY well for me(using spec 60 new master, and CO...

We have spent nearly 3 days trying to get the brakes on this FJ to work. 1. We rebuilt the master cylinder and could not get the brake system to build pressure. 2. After many hours rotating from wheel to wheel we realized that one of the drivers side wheel cylinders was leaking. 3. Got 4 new...

Does anyone know the # of the bulb needed for the seat belt and parking brake warning lights? I've looked everywhere but found nothing.

We are having to replace the brake master cylinder and curious as to how to remove the reservoirs. I am not there and my dad is concerned that he will break them by doing it wrong.

Hi Non Mechanic here. On my 2005 Landcruiser, the driver side front wheel well area is getting wet with fluid. It appears to be coming from under the brake fluid reservoir/ pump area. I did the brake pump test and the pump engaged with a faint alarm clock buzz for 3 ten second or so...

I have an 84 fj60 about 2 weeks ago my red brake light started flickering and the pedal went to the floor no leaking anywhere Reservoir remained full but I had no brakes I replace the master cylinder bench bled it first after I got it installed bled the entire system now seems like I Have...