brake

Hello, I am a new 100 series owner and as I've been driving it lately I started to notice some brake fluid leak on the ground under the driver side. After reading a lot of the posts here none of them seemed to match to what I think may be happening, but I just can't figure it out. After cleaning...

I was driving my 2004 LC up a paved mountain yesterday and in a very slight turn, it felt like the front brakes briefly engaged for about a second. The steering tightened up too but only briefly. There was also an audible alarm. Earlier that day the vsc light was on but it went out prior to...

Evening lads, I could well be exposing myself as the idiot I often am but I'm at a standstill and need some help. I have searched partsouq, FSM and mud to no avail. Does anyone know the P/N for the bracket that attaches the parking brake cable to this point on the fuel tank strap. I stripped...

Brake, ABS, and Traction lights come on after about 5 minutes of the engine running. Doesn't have to be driving- even 5 min idling in the driveway will throw the lights on. Had the codes read and I got the following: C0226 (Open/Short circuit in Hydraulic Brake Booster Solenoid SFR Circuit)...

Short story, 2018 Cruiser. Put dot4 brake fluid in. Cap says dot3 on the 2018. Was talking to Slee about their stainless brake lines and we started talking fluid. They checked a 2021 cruiser in the shop and it said dot3/dot4 on the cap. Question, does anyone happen to know if there were...

Kid at discount tine was convinced he was in a Fast and Furious movie, and snapped off the button on my parking brake lever. (listed as Knob - 46217 below) It's snapped off down inside the handle exposing the threads. I think i have a replacement sourced(Part is discontinued), but I'm...

I'm working on our '93 FZJ-80 with discs all around. I did the calipers and pads a while back. The rotors, from the outside, looked fine and I ignored them. The typical "warped rotor" feeling came, I think getting progressively worse after the job. Pulsating while on the brakes. I had heard...

I converted to discs on the front and have everything associated with that for free to whoever can use it. All came off of a 1975 fj55. Some of it is fairly new (within 15,000 miles). No leaks from the brake cylinders and the shoes have plenty of life left. Maybe someone would just like spares...

Hey guys I’ve got a 91 80 series hdt Having problems where the hand brake is basically pulling itself on, I only believe it’s the hand brake as when driving and pulling the hand brake on the noise it makes goes away(I forgot to add it makes like a clunking noise, the car has new rotors...

Anyone find any tail/brake lights that will fit in the dobinson rear bumpers? I've been searching but coming up empty. They are about 60mm or 2.3 inches. Odd size for sure so it is hard to find something that isn't just trailer marker lights.

After 35 years of ownership I find myself diving into the possibility of brake booster replacement. All the other braking components in the system, including the booster check valve, have been thoroughly assessed and the symptoms of a very stiff brake pedal resistance with increased stopping...

Rebuild front axle less than 1000 miles Includes steering tie rod and drag link and brake lines Rear included . Just bolt in and go $1500

Nevermind - figured it out.

I bought a used OEM spoiler for my LX470 and would like to find female connector for the high mount brake light to make it fit exactly like factory. I know this is waterpoof connector that is also used by toyota for ABS sensors. Can someone help me find the part number for the female connector...

I've been removing some aftermarket antenna stuff (am/fm and uhf cb) from my 80 today and got curious about the vacuum setup that is used with the brake booster (no clutch booster on Oz 80's). I've never seen any sort of warning light show up or any sort of buzzer making a noise, so I'm not...

I have a 77 FJ40 (5.7 swap) I had some smoke from my exhaust and realized it was my brake fluid dripping onto it. Specifically it’s draining the rear reservoir ( yellow circled area, ) coming from the bolt inside. I have never had to work on a master cylinder so I’m not familiar with trouble...

I was working on bleeding my brakes yesterday and noticed that when my daughter was pushing on the brakes that brake fluid was spraying out where the brake line mates to the proportioning valve? Will a bad proportioning valve do that. The flare on the brake line looks ok to me. Any advice would...

What is the valve under the master cylinder?

Just had rotors turned on 2015 @ 30K.......no more vibration, but now pedal drops further. Assume result of less meat on the rotor? Did not change pads 8MM. Brake fluid reservoir about 3/4 full at rest. Any concern? THX

I have a 1970 FJ40, original F engine, most everything is original as far as I know. Aftermarket temperature gauge, normally operates around 180-200 deg F. Once it gets above 200, you can tell the thermostat opens and brings the temp back down. Have had it this way for over 10 years without...