angle

I've got some mild vibration at 45 to 52mph from the rear of the truck. I pulled the rear driveshaft to verify and I've got a DC front driveshaft. To correct pinion angle, it appears I have several options: Install adjustable upper control arms. Rotate the top of the axle forward for proper...

In preparation of installing Ironman suspension on my LC, I am doing a diff drop. The front ride height will only increase by 1.5 inches. I recognize that is not much, coupled with the diff drop, my boots “should” be fine. I am replacing the CVs with Toyota OEMs. As I want to try to plan for...

Hi all. Can't solve the problem with steering angle readings in VGRS and AHC. Earlier fixed VGRS intermediate shaft. Works good now and no any VGRS truble codes. Did VCS zero point calibration in accordance with Issues after new steering rack. Zero point/steering angle/VSC -...

Hey all, Im trying to piece together a super short driveshaft with a steep angle. Ive got a 4runner double cardan front driveshaft but it seems like the cardan head is pretty lengthy (7.5ish inches from weld to weld). Any suggestions on the most compact double cardan I could replacethis with...

I'm sure its here, but I can't find it. I put OME 2.5" lift springs on my Fj40. I also put on new SOR greaseable shackles. After a year of driving around, the shackles are still nearly vertical, front and back. Is there a solution for this? I run a hard top from September to May, then...

Hey guys arfter some opinions on my shackle angle and the pin location. Ive just installed ironman +2 springs and standard length a.i shackles in and the pins are touching the hanger mount with the truck off the ground. Then sitting there is around 15mm on driver side between pin and hanger...