2uz-fe

Selling the 2uz-fe out of my 2002 land cruiser. runs great. I've put about 3k miles on it generally got 12-13mpg around town and 15mpg hauling a small trailer, all highway to Canada twice. the LC has 330k but I was told the engine had 145k on it when I bought it. Doing a Mercedes diesel...

Parting a 100. Email or pm for pics and prices. Deo

Looking to sell my LX 470. Recently overheated, engine is done. It has almost 420,000km on it. I am really trying to avoid sending it to the scrapyard, it would be a waste. I don't want to part it out, you purchase the entire LX. Price is $4500. The good stuff: Body and interior are in...

US spec 2006 UZJ100 complete drive train (engine w/computer, auto transmission, transfer case) Perfect turnkey opportunity for a swap or great condition low mile replacement 106,881 miles (about 9800 miles a year) video of engine running available upon request (couldn't upload it for some...

So we are looking pretty seriously at buying a GX470 for Rachael (03-08 seem to be in the price range). They come with the 2UZ-FE, which I love, as they are pretty well known for dependability and hey, it's a Toyota, I should be able to work on it when anything goes south on it. Quick...

I'm a former owner of a FJ62, but now have my sites on a 2001 LC. I'm in the midwest so all I have been able to come up with are great running (as far as I can tell based on a test drive) rigs with an absurd amount of rust on the frame/undercarriage (not surprised). I was looking to spend $15k...

So pulling the valve covers off today to change leaking gaskets and checked valve gap on passenger side cyl 2 4 6 8 2000LC with 170,000. Valve Clearance per FSM cold Intake : 0.015mm - 0.025mm 0.006in - 0.010in Exhaust : 0.25mm - 0.35mm 0.010in...

Looking for a full trd super charger kit for a 99' Land Cruiser. If you got one, name your price. Thanks!

A GX 470 has become available. The exterior is mostly destroyed, but the motor and tranny work fine so I'm going to swap them into my 1993 FZJ80. I've found other 2UZFE swaps, but none from a GX470. Is there a reason for this? What do I need to know going into this? How does the geometry...

Has anyone pulled out a 2UZ from a 100 series before ? Can I just pull the motor or is it better to take the engine and trans together? I'm thinking it might be hard to get it back on the trans later ? Also is it easier to undo it at the end of the trans rather than the bell housing ? Has...

I bought this unit in early 2016 for my 2000 Land Cruiser, refurbished completely and thoroughly including new MP90 unit. Since then it has been sitting in it's packaging, waiting to be installed. But after much deliberation, I decided not to go through with the install. Will part with it for...

I have a 2uz-fe engine which I have removed the right hand head. Unfortunately i didn't remove the lifters before turning it over and as a result all the lifters and shims fell out. i know how to do a valve lash but my question is. With all the lifters and shims out and no way of knowing which...