2uz-fe

Hey all, Just putting this out there to see if anyone with a TRD supercharger for the 2UZFE would consider selling. Feel free to reach out with any questions or information.

Part no. BD20-15DDUL from NSK fits the drive belt Idler Pulley part # 16604-0F010 in the 2UZ-FE engine. Found on the 100 Series Landcruiser/Lexus LX, GX, etc. A new pulley from Toyota costs $77.19 as of 6.15.2022 from McGeorge Toyota I currently have 14 available units. I thought I'd open...

Hey Mud, I purchased my 2004 Land Cruiser about two years ago with 125,000 miles. Currently has just shy of 139,000. I've always thought the engine was a bit loud and after searching on here I found a few comments stating that these have a "loud idle" so I never thought much of it. Well that's...

After months of looking, I finally picked up a 2000 LC with 219k. The previous owner said it was well maintained and had another 06 himself. He was actually the second owner and his neighbor was the first. He was given some error codes by Toyota equaling up to about $5k. Thinking I could...

Yesterday my 100lc was running very rough and I got a cel for a cylinder 8 misfire. I thought I would just go change the coil but when I went to change it I found the cable that connects to the coil was very loose above it where it connects into the wire harness. I pushed it black in and the...

Thought I was gonna replace the thermostat gasket but nope… Can someone tell me about replacing this gasket/resealing this part? I have no idea what you call that hole so I don't even know how to search for it.

Hello, I recently bought a 2004 gx 470. Upon checking the coolant, it has this gray gooey stuff insider the radiator and overflow tank. No engine lights, doesn’t over heat, no smoke from tail pipe. Maybe the previous owner tried to fix a head gasket leak with a liquid head gasket repair kit. The...

I have a 1964 Fj40 that I am retromodding to be a rock crawling rig. I bought a running 1999 lx470 to flip for a profit, but ended up considering the idea of swapping that drivetrain(Engine, transmission, transfer case, and rear axle) into the fj40. The original plan was to swap a Cummins R2.8...

Hi everyone, So I have searched the forum and have not found a similar thread to mine, so the issue is that my lc100 with the 2UZ engine always takes a long time to start on the fist crank. However, if I switch off the engine right after it starts and try to start it again the car starts right...

Hi everyone, I have a problem with the oil pressure sensor wiring, I have recently purchased a 100- series landcruiser and noticed that the oil pressure gauge is maxed out, upon inspection I noticed that there were no wires connected to the oil pressure sensor located on the engine, i have...

Hi everyone, this is my first post. After years of wanting to own a beast, I finally have one. I’ve recently purchased a 1988, 75 series LWB. I want to upgrade the engine and had either diesel 1hd-fte or the petrol 2uz-fe in mind. I also plan to swap the gearbox for an auto ( sac religious I...

I am in the middle of rebuilding a 2UZ-FE VVT-i out of my 2007 Sequoia after I hydrolocked it and snapped a connecting rod. When I tried to put the driver side camshafts in the head they would not sit right but I decided to tighten them anyway because that is what my Haynes manual said. When I...

Hey guys I’m currently working away so can’t measure it but want to replace my 100 series muffler as it’s abit wrecked and I might aswell get some better sound while I’m there. I have searched high and low through the forum Along with other forums and emailed Toyota dealers but have found...

I have a 2007 Toyota Sequoia Limited with the stock 2UZ-FE engine. I have read that in either the 06 or 07 models Toyota began to add VVT-i to the 2UZ-FE and in doing research I saw that the old TRD Supercharger doesn't work with the VVT-i engine. I am looking to put a supercharger on my engine...

Hi all, long time lurker parting with a complete TRD supercharger kit off my 2004 Sequoia. Charger worked fine and made boost when installed but I have not mechanically opened it up for inspection. I don't need the power, fuel consumption or complication with a new baby here so it must go! The...

I bought 99 LC this past summer. it has a check engine light on- for knock sensor. I have searched all IH8MUD site and internet for sensor's location. I looked on the driver side of the motor under the manifold and block. but didn't find it. does anyone know where exactly in the motor the...

Hi everyone, I'm a new member and this is my first post. My '04LC does not have a dipstick to check the transmission fluid level. How do I know if the transmission fluid level is correct and how do I check the condition of it? Currently with 137k miles. Was used normal driving not towing or...

Is it possible to replace the water pump without removing the timing belt and everything associated with it? I had the timing belt done 30k miles ago and should have done the water pump at the same time because now its going out. There is a ton of info and videos out there for doing both pump...

Hey guys, Anybody heard of a place that modifies ECU's for the 2UZ-FE engine that strips it down to the basic essential engine functions? I'm hoping for an ECU stripped of the immobilizer, emissions, and other uneccessary functions. Any leads? Thanks! -Kyle

Hi all. My daily driver wouldn't crank today. Summary of vehicle: 2003 UZJ100R, V8 petrol with 5 speed auto transmission. The engine is a 2UZ-Fe 4.7ltr V8. It has 240,000kms on the clock. I've only had it since the start of this year, and I suspect the previous owner spent a lot of time on the...