I guess I wasn't totally happy with the solution. I never felt like I quite had the modification dialed in. Nothing wrong with it in the bump stops worked but I feel like the setup could have been better.
I'm hoping to find out what people have done when they've installed advance adapters twin stick kit on an h55 f and split case. Particularly the two shift levers, have you bent them out so they are farther away from each other? Did you do that after the boot? Are they parallel when in two-wheel...
I'm seeing a few products discussed, all so far are 2 parts that mix during application via a special applicator gun. While this is apparently the most common solution I'm wondering about single part products that can be applied with a standard caulking gun that will perform similarly. Is this...
John, I have a replacement for that heat shield for you here. As a matter of fact I have a couple of those heat shields from underneath that I will get to you.
I'm not 100% sure what that fuse panel was put there for. It may be for the upper hatch lights with the expectation of eventually adding over landing power back there. The wiring on the other side was from the previous owner to me for a trailer lighting connector.
Good choice, I hope removing the floor crap goes well. That was there from a PO when I got the truck and I never had the gumption to deal with removing it. Post pics of what you find underneath.
PS: and don't forget to order up a supply of FluidFilm (etc) for the underside!