Got an 07 Cruiser. Got my windshield replaced yesterday (Oem Toyota) and noticed my front headliner is down about 1/2 inch. Is there some trim piece that’s supposed to go across? Or did the glue give way. Was thinking about added some beige rubber edge guard or something. Wanted to see if I’m...
My truck didn't have that block or it was removed prior to me taking ownership. I think I'm just used to the quietness of the 100. The skids changed that by blocking the driveline in.
Another update
Went to a muffler shop to have a new y pipe piece welded on. They were able to cut and remove the old piece with the bellyplate in place. I got about an 1-1/2 inches now with the new piece BUT I still have the vibration during a cold start in the morning. It only happens in gear...
Update
Cold start this morning it sounded like there was contact somewhere. It went away when the truck warmed up but I'm thinking it is the exhaust. The other slight vibration could be the harmonics of the exhaust / airflow/ driveline noise bouncing off of the steel plates
The hum gets louder...
I installed my full set of steel skids from slee last night. I noticed that the truck has a slight vibration now. I checked all the bolts and everything is tight. I am wondering if it's the exhaust pipe. It comes very close to the belly pan like 1cm or less. No rattles or squeaks just doesn't...
I am currently running the 1.5 ome kit with fox 2.0s and wanted to add a slee rear bumper/tire carrier to accommodate my 34s I plan to get soon. I don't plan on adding drawers or enough weight to reach the 440 pound heavy spring rate. I was wondering if anyone has tried running the 2.5 medium...
Thanks for the replies!
I've heard of notching with metal techs. Seems strange the guy you sold them to had to notch with the slee step Sliders. I would think all of their stuff is made to work in unison.
I've been looking at pics and I think I'll have to notch. I would rather notch then move...
Just pulled the trigger on a set of slee steel skids. Wondering if I'll have to notch the belly pan skid in order to clear the ubolts.
Anyone have this setup? How was the install?
Thanks!
I just got my truck back from TJ performance in Orange. Had OME 865s / Torsions / diff drop / Slee Ucas / Fox 2.0s. Truck rides Amazing much better than stock. However their idea of level differs from mine. They had the torsions cranked so high there was 15mm of down travel.
Before
After...
Seems a little steep for the amount of miles. I paid 17 for my 05 with 130k miles last year...but yours is an 06 non AHC. Those are kinda rare. I wanted a non ahc 06-07 but could not find one. So I settled on doing the front conversion on my 05 :). I say offer him 15,000 only if the timing belt...
So my wife was sitting in the back with our 1 month old and she noticed her seat belt was damp. It was damp on the section that can't be seen. I'm thinking it's either my gamiviti rack leaking. The middle mount is literally right above the seat belt, but I'm unsure if it can drop onto it. (hard...
Hey everyone.
I have an 05 and started tackling my diff breather extensions. Is this the tranny and t case breather? Looks like they both are tied into one unit. Is this correct?
Anytime you cant paint around something you run the risk of it chipping easier because it creates an edge. The amount of time it takes to tape everything off you can just remove the trim and paint it off the car. This way you won't have over spray. Up to you