Yes, you read right. I want to go auto.
I believe these things came out with an A440 Transmission as did the 60 series. So locating a transmission and Converter should not be a problem. I assume I need the Auto Flywheel as well.
Which 60 series Transmission/Engine has the same bolt pattern as...
Go get yourself some Dr Tranny Instant Shudder fix.
http://www.amazon.com/Lubegard-19610-Tranny-Instant-Shudder/dp/B0002JMLQU
If it is your Torque Converter and its slipping when going into lock up, then this will help. It may fix the problem, it may not fix the problem - it certainly will...
Hi all,
I'm midst a veeeeerrrry long build on my Bundera and I'm head first into wiring. I've found a few plugs in the engine bay that I have no idea what they're for.They don't seem to have anything to do with the running of the engine as mine (Chev V6 229ci) is running fine with the temp, oil...
This is the reason I couldn't find anything about it when I searched '4th gear vibration.' As you said, It is actually when the Torque Converter locks up around 70kph, the vibration starts. 50kmph drives smoothly.
Upon a little more investigation, it must be over drive not 4th gear and it seems this is a common problem usually caused by a Torque converter failing. It's not bothering me too much ATM but I'll do the drive shaft uni joints and flush the tranny a couple of times and cross my fingers...
Rightio. I have an automatic (a440f) sitting behind a 12ht. When I casually accelerate up to 70km/h, it changes into 4th gear. The second it changes, I get this nasty fast vibration coming from the rear of the vehicle. I can make this vibration continue if I hold the revs and speed. Although...
The angled part of the tank looks like it goes parallel to the diff and the rectangle cut out must be where the relocated exhaust goes.
If that's the case, the filler lines etc would be directly facing the driveshaft. That doesn't seem right?
If you have the chance, I'd love to see a pic or two of you tank installed. I had a look underneath where you were talking about but I just can't get my head around the mounting positions. None of the existing bolt holes seem to be in the right positions.
It did come with a couple of 'U' bolts...
I haven't had a good look at the steering yet. It's on my to do list. The tie rod ends visually look ok but that's the extent of my inspection so far.
Here's the pics you requested. I suspect you are missing the inner most mount for the seats.
Isn't the top hose the outward side of the radiator? It's should be a lower reading than the bottom. Can't help with the actual temps although I'm interested to know as well.
So today I went and picked up the 'new' front seats. They need a good clean but are solid. The drivers seat has electrics!
I also bought the original roof lamp. The PO put this awful LED light in there. Waaaay too directional. It didn't spread any light at all. I'll still replace the old...
Haha. I did actually spend a year down that way in Nowra. The only appealing thing about living down there was Yawal and the Jervis Bay Area.
I found my way back to Townsville less than a year later.
Thanks guys. The trip from Townsville to out past Charters Towers for prospecting in the petrol 4wds was just killing me.
I only have an SD2000 for prospecting and an Extera 705 for coin and relic and still only learning so the rewards aren't that lucrative. Although, it's not the monetary...