Heater hose routing, searched all over and cannot find the pictures needed. I'm talking about stock F and 2F. My pics are 2F with an oil cooler. I would like to get pics of other stock routings of 2F's and F's, this comes up so often during Winter and frame offs. I hope mine is correct....
While probing around to find the freezing wind I found a constant stream on the inner roof. Tried a bunch of different tapes and found the aluminum adhesive tape is the ticket, went all the way across. This not only cut off the wind blowing in, it stopped the smell of exhaust I was getting, I...
Oh man! Just missed pulling out in front of someone, it was due to the reflection in the side window glass. I'm sure everyone must see if you drive at night. At certain vehicle angles the reflections on the side glass are from the other direction. Question: Anyone tried spray on glare reducing...
It was sultry, no it was raining and I wanted to try the cruisers new wipers and the defrost stuff prior to Winter. Started down the driveway on a downward slope and about a cup of water comes flowing down both sides of the roof rails and splashes on the windshield (on the inside). I remember...
This pin is loose, rocks side to side and causes play in my steering. I haven't pulled it apart yet, trying to decide what to do. Should I weld it in place or is there some way to tighten this thing. Thanks.
I tested like this :steer: and my center arm moves 1/2" side to side. I popped the cap and all the right parts are in there, I guess this means the bushing is bad. Picture shown, SOR wants $100, dealer has one for $125. Good greef.....Anyone have a solution for this. I plan on a steering...
I found this great list from TOBASH . Thought it was worth reposting:
My recipe for new-to-me car safety
1) Change all fluids, filters, belts, etc... New stuff means less risk of failure and it means you know from day zero what ya' got.
2) Change the f'ing brake fluid too!!! It is also a...
The number is F 257535. From what I can find it is pre 69. Will it have domed pistons? Checking to see if I could put this head on my '79 2F with a bad head. I would have to rerouted the oil line and from what I read water passages are OK. Any comments??
Just about to put the pan on and thought I might clean the goop out of the bottom. Found these. Any ideas?????? As soon as I identify these I can put the pan on.
Thanks
Anyone have something tricky to break the head loose? All the bolts are out including the middle one. Everything on this engine has had high temp silicone on it so who knows what they did with the head. Thanks.
I received some misc. parts from a friend and one of them was a solenoid. I was going to install it on a tractor but during my testing found out that is wasn't just a regular solenoid. If you pulse the activation contacts the solenoid opens/closes and stays that way. It latches On with one pulse...
I remember someone cutting a piece of aluminum to make a homemade channel for a bikini top. I know I have seen it but I searched all over. Any one know where that is. Thanks.
Finally found the lug nuts alot of mudsters have been looking for. I know of at least a dozen folks asking/commenting about a solution for the aluminum wheel issue. This set is perfect. 120mm 150RH, Buldge, short shank, cool locks.
The shank is the part that goes around the stud and most folks...
3 point seat belts in my 79 are worn and i"m trying to plan what to do. Anyone found a good way to clean the belt? My thought was to remove them, stretch to full length and wash in a 5 gallon bucket. Anyone used liquid dyes to change color?