100 series rear spring bump stop off a 2001 model $35 shipped continental US only, removed several years ago when airbags installed, cleaning out shop and offering them up here in case anyone can use them
Need to find a Landcruiser mechanic with Landcruiser experience. I have a 60 I am redoing and two 100s need routine maintenance as well as some suspension and drive train work. If you know of anyone please let me know
Took my 1983 FJ60 to have the transfer case seals replaced. Front was no problem. Mechanic said he worked all day on rear drive shaft and can not remove it from vehicle. How can it be removed? will it have to be cut off and if so any idea where I can find another one or will I have to have a...
Saw ads online for theseatshop. I do t know anything about them and they don’t currently make them for the 60 but I filled out their product suggestion form and thought maybe if others were interested and filled out the form maybe they would consider producing some.
What can I do to fix it?
Bought cruiser with 155,000 miles replaced both cv axle joints with new Toyota and installed Slee diff drop kit. 30,000 miles later and I already had to replace the right one and now the left one is going out. Any ideas on what I can check or do to keep them from wearing...
My 100 has intermittent vibration where the steering wheel oscillates back and forth, if I apply pressure either direction it lessens but does not go away. After it started I drove it to my mechanic and it was so bad I thought it might cause me to run off the road, speed was 15-20 mph was the...
Bearings in my spare tire carrier are shot. Wondering if anyone has replaced them could tell me if they are a common bearing I can get at a part store or something I am going to have to order from ARB?
My newly purchased FJ60 had had the air rails cut off and the lines welded up, the pump and everything else was left in place. Is the pump currently doing anything, and would removing it and replacing it with an idler pulley do anything detrimental to engine operation? Would it be beneficial...
What does this valve control, I can’t tell from the diagram what this one mounted on drivers side fender controls. The wires to is have been cut. Trying to find out is I should hook it back up. Other than the upper bvsb having the nipples broken off, and the air rail being cut off with the ports...
Disassembled carb for cleaning and it was missing rubber seal on primary Venturi. I’m going to try dealer tomorrow but some of the online dealers said NLA. Anyone know where else to source?
Choke will not close because it hits the arm with the green tape on it. Pictures I am seeing of other 60s the arm appears to be sitting further to the right out of the way of the choke linkage, should I loosen the nut on the arm and move it further to the right? Thank you for any suggestions
Just bought 1983 FJ60 and need held to I’d a few parts. Can anyone tell me what this is and where it plugs in? It is on right side of engine and was hanging under distributor.
These came from SLEE but I am not going to use them. They are new in the box.
Part #STF1078 WHEEL SPACERS 1.25 (5 ON 150MM) with lug nuts- HUB Centric- pair machined for full floater hub- fits 1998-07 Landcruiser 100 series front only (WHS_022) retail $155.00
Part #STF-1079 Spidertrax wheel...
New in box set Factory Toyota disc rotors bought for 1996 80 series. Part # 43512-60090.
$150.00 shipped anywhere in lower 48. Price reduced $125.00
Located in Wynne, Arkansas.
SOLD