Thankyou again.
Having a deeper look into the local availability, it seems that there is an better availability of Mitsubishi turbo's and goodies here. Most have the funny OEM compressor housings but good solid TD4 cores are available. I have not seen too many AR values on the turbine housings...
Thank you all so far. I'm going to shift my attention to the TD series as suggested. Aquick look around shows that there is some support for them here in SA.
Is there a Mitshubishi turbo guide or bible around. I want to gen myself up on them soonest. any info or reading matter appricated. (...
R2554R Shoot me down.
Hi all, I have been very happy with my NA 1HZ in a 2007 76 series wagon. I am almost officially an "Old Fart" and never had the lust for speed and brute power.
We have recently started touring our neighbouring Lesotho where the average height is just below 3000m above sea...
Toyota themselves turbo a number of IDI engines so not to worry there. I would only replace head bolts if yours are TTY. the main thing about IDI with a turbo, and this comes up again and again, is the extra heat in the head, so an intercooler and perfectly running cooling system is a must...
Just need a bit more tidying up of the heavy wires and cutting off the old roller hawse attachments. Got to pull the lot again as the bumper needes painting and the winch needs rebuilding ( not free spooling very freely)
I had to remove the grid to get some grass off the radiator and then this happened. don't ya just know it
The old pack sat on top of the bumper and was, in the way, frying in the sun, and badly wired ( PO obviously). So I rewired and put it under the bonnet ( Hood) . On the 76 HZ it fits...
Hey all
My HzJ76 has a 275 mm clutch and when I replaced the R151 gearbox with a real H150, I had to look around a bit to find a 275 clutch plate to suit the 32mm 14 spline of the H150
and go under the 275 clutch cover. I used a combination of Exedy cover and Asin (Toyota) plate, and had the...
A little off topic, but this may be relevent to all, and the thread!
Could this advance mechanism be so worn that one cannot set the advance using the stipulated method. I have worked on two rotary pump engines where, try as i might, i could not set the advance, and resorted to using the marks...
What I am curious about is: If you have an isolated version in yer grubby little paw, can you short the two negatives and make it an non isolated version???? I could not find this info on the Victron site.
When is this tool supposed to be used please. I have watched a number of "70 front end-rebuilds" on u tube and never seen any kind of centering. Are they just winging it and hoping that the new bearing is close enough to the old one size wise. Their most sofisticated tool seems to be a small...
Looks like you have enough room to place the w/a cooler right where your current turbo to intake pipe is. you would not need a large unit for this engine. I think your biggest headache will be the w/a radiator placement and hookup.
G
For a Pain Free, you must go for a complete ( With TX case) H150 from a 70 series vehicle and get all the katunda with it, gear levers, clutch lever, rubber bellows with plate, and linkages. You are a 2013 model?? so its wide body with front coil springs and a bonnet hump? In this case you...