I'm helping a friend with a 74 and he's looking at going with the Holley Sniper. Where did you get your setup and what all does it need? Nice build!! Thanks!
Looking for some advice or knowledge here. My 97 is wearing the front, passenger side tire from the center to the outside. It has had the OME 3" lift on it for over ten years with no issues. I took it to my frontend shop to see if something was "out" or to see what had changed. They put it...
Looks like you have most of the 80 parts I'll need. I'm starting with a valve cover job on the 96 4Runner and It doesn't look like you carry those parts. Any suggestions? Thanks!!
Getting ready to do some maintenance on my 97 80 series and the 96 4Runner and need Toyota parts. I used to buy a lot from Dan @ American Toyota but it's been a while. Who are the goto parts guys now?
Thanks!
I usually buy only Toyota parts for my Landcruisers, with some exceptions. July of 2020 found me in an O'Reillys parking lot with antifreeze pouring on the ground from under the hood of my 97 model. After a quick inspection I found the heater control valve had blown up. No problem. I...
I'
I think the Bowfin is the one I like best. That looks nice and clean. Also appears to be very sturdy. Their website say's it's sold out. How long was your wait?
I have been looking into adding a roof rack to my 97. I currently have the Thule cross bars and a NAPA awning attached to my factory rack and would like to add a rack/basket to the existing setup. Are there any that are being used that won't break the bank but worth spending your money on...
I just mounted it up to my factory rack. I drilled and used rivnuts. Ran the bolts through them so there are 2 pairs of bolts sticking up on each side now so it can switch sides by simply removing four nuts, then adjust for other side and tighten down. Worked out nice and the wife loves it...
Just got this awning and was wondering if there are any specific reasons on which side to mount it? DS or PS? Is it just personal preference? Anyone with ideas on which is best? Thanks!
Digging deeper into the Sniper EFI install.
The PO of my 40 installed the Weber carb. In the process he unhooked the charcoal canister and removed the separator and plugged all the lines. It would vapor lock occasionally until I vented the gas cap. It has run fine since, except for the usual...
I'm looking at upgrading my 76 with the Holley Sniper EFI. I currently have a Weber Carb that I can't seem to keep running right. It's always running too rich and I'm not great with carburetors so... I've been attempting to get in touch with the Holley techs to see exactly what is needed...
I bought the same set as the ones originally purchased, for about the the same price, just a couple of months ago off of eBay. The ones I see on there now are outrageously priced.
I was looking for some snap rivets today and found this site with tons of different Toyota fasteners and other related items. Thought it was worth sharing.
ClipsAndFasteners.com - Automotive Retainers,Clips and Fasteners
I was looking for some snap rivets today and found this site with tons of different Toyota fasteners and other related items. Thought it was worth sharing.
ClipsAndFasteners.com - Automotive Retainers,Clips and Fasteners
Help!! I’m trying to find a source for the plastic snap rivets that attach the defroster vent to the dash. Anyone have a source for these? Can’t find em at any local auto parts stores. Thanks!
Sounds great. My stock motor is still in fairly good shape but as soon as it's done, I'm going to do the LS or a Cummins swap. I'm guessing the LS is at least 1/2 what a Cummins swap would be.
I've got several friends here that are in upper level racing business, building race motors and...