I have the C59-535 coils installed but gave me more lift than I was planning on. Would like to swap for the c59-559V if anyone is interested. Or purchase if anyone’s pulled any off. Located in Austin, TX.
I’m trying to narrow down potential causes. One of the symptoms I’ve noticed is that the hvac blower seems to be staying on after the vehicle is turned off, at least in the defrost zone. Has anyone seen anything similar?
Installed last summer but just swapped for some different ones. Less than 10k miles with stickers still on them. $200 OBO in Austin, TX but likely traveling between east TN and CO this summer.
Finishing up the install and realized that the bumper comes with separate turn/parking signals on the bumper, but in the OEM setup, the only turn signals are on the headlights. Did others wire the new turn signals in the bumper into the wiring for the turn signals? or do something different?
So i installed the Dobinsons IMS setup about 5k miles and feel like i've gotten excessive lift in the rear. Stock weight on the C59-535 coils (which should yield 1.5") has put my hub to fender measurement at about 24" (so 4" inches of lift). I went with the C59-540 front coils (1.4" lift) so I...
Question here. I recently installed dobinsons IMS suspension on my 2014 LC200. I installed the stock weight coils for 1.4" front and 1.5" rear lift. I had the alignment done afterwards by a toyota dealership but caster is still outside of spec. If others have installed this or similar...