Search results for query: *

Forum search Google search

  1. mbsilvia

    Specter Offroad

    This is a bummer. I used to order from them all the time. I'm now rethinking it. I wonder if they realize that the few bucks they're saving is slowly alienating them to the biggest cruiser club in the world? Smh..
  2. mbsilvia

    New F & 2F carbs

    Is there a waiting list as of now? sorry if you already answered this, I jumped to the last page. I need one for my fj60, and also are there any aftermarket air filters that will bolt on, similar to a weber? I'm absolutely buying one:)
  3. mbsilvia

    cummins 6AT

    Yes it does have a flywheel for a standard clutch. It is super burly and could be machined to fit just about any clutch within reason. Thing probably weighs about 25lb:) When I bought this engine I had done research and found that this is a very smooth setup and gets anywhere from 28-32 mpg...
  4. mbsilvia

    cummins 6AT

    6AT Ok guys i'm dropping the price of the engine. Lots of lookers but no for sure takers yet. $1400 come and get it!
  5. mbsilvia

    cummins 6AT

    no starter, or bellhousing, but any chevy bellhousing will work.
  6. mbsilvia

    cummins 6AT

    I've got an original cummins 6AT for sale. Bought it a few years back for the fj60 but decided to finish another project needing funds. Around 160k(miles) and ran strong before pulled. Fully mechanical, just 1 wire hookup for glow plugs, bolts up to chevy bellhousing, comes with bosch high...
  7. mbsilvia

    So...whats your cruiser resolution

    Get in the 6at! Well I'm gonna try at least. But first comes painting the engine bay...eww...
  8. mbsilvia

    Used H55f Transmission for sale

    trade? I will trade you a 72 fj55 and a 2f,trany and t-case out of my 60 for this tranny
  9. mbsilvia

    Parting out a 1986 FJ60

    yea
  10. mbsilvia

    Diesel Engines

    interested can I get a phone number, I am interested in the 4bta
  11. mbsilvia

    Putting in trailer wiring: how to do it *right*?

    trailer wiring I usually splice a foot or two in front of the rear bumper, everything should be there except for trailer brakes, which if you need, you will be running a wire from the brake adjuster to the back, in which there will be a diagram with most you purchase. As for the trailer wiring...
  12. mbsilvia

    propane

    Has anyone here tried converting to propane? I am starting to a little more research because I hear that it has higher octane levels than pump gas, therefore allowing a more lean air fuel ratio. Lean ratio means less fuel per firing equaling better mileage. I have not done much pricing on...
  13. mbsilvia

    Is this bad...radiator foaming

    head gasket I have blown quite a few headgaskets in various vehicles, and that is usually the first sign, check your oil, it will be milky looking. You will also find the temp guage going up often and losing water. good luck
  14. mbsilvia

    How deep is too deep - found out the hard way

    been there I drown my fj55 a while back, just make sure to change your oil before you drive it, well, if it looks milky. You usually will suck up some water through your front main seal. Other than that, you shouldn't have any other worries. BUT, if you sucked up water through your intake, then...
  15. mbsilvia

    Another OME Leaning

    mine too Mine leans too, but the letters were worn off of the springs before I got them, I wonder if there is any other way to tell which is which.
  16. mbsilvia

    Conversion Question

    i'll sell you an engine I have a 94 toyota 1jz-gte twin turbo automatic swap that is beggin to go in a cruiser, I'll even throw in a divorced sammy t-case, $1700. If you don't then I will put it in my 60
  17. mbsilvia

    60 springs

    I have all four fj60 leafsprings,STOCK, for sale. $100 for the set. 360-223-0914
  18. mbsilvia

    Kicker Amp and or Kicker Subs

    price how much for all and for them split up?
  19. mbsilvia

    Lift kit advice (Ironman) , alignment issues, and what else?

    lift kit Hey Man, I went with the ome 3" springs and a 1" shackle, the only problem I had was getting the spring hanger bolts out, (not the shackle side.) I agree, you should definitely do it yourself, it's a kick in the ass! Along with my springs and shackles, I needed longer shocks, and...
  20. mbsilvia

    Is this a good price? I need help!

    beautiful Nice setup, it is identical to mine! I think you can get that out of it. Hey, what kind of mileage do you get with that weber if you don't mind me asking?
Back
Top Bottom