I have a 87 turbo supra motor
missing items:
turbo,manifold,ecu,iol pan,pickup
1 gear is broken(cam gear not the cam)
I have the turbo bellhousing that goes with it,coil pack,intake manifold with throttle body
I had the motor for a 4runner project that I had going and was planning on using...
78 fj40 forsale
169,000 kms on it (origional milage)
pretty much stock
full removable hardtop with rear ambulance doors
has rear stock tire carrier
Tub Was recently fully replaced
front calipers were replaced.
glass is all good no cracks
electrical works
guage cluster works...
I have a 2F motor forsale from a 83 fj40
It has 69,000 kms on it runs fine. Motor is a complete long block
Carb,manifold,alt,starter,distributer,cap,rotor,plugs,wires,the whole nine yards.
$400 Canadian pick up only at the current time.
sorry no pics.
Matt
pm me if your interested.
Thanks for the info, ya I threw my super swampers on drove down the road and she started to vibrate bad , then the shaking came. Looked and the tie rods were dead.
I was wondering whats a good tie rod end out there I put some 33" swampers on my fj40 yesterday took her for a drive today and just my luck all the tie rod ends went on me.... mind ya the 40 sat since 97 finually got her all up and running.
I bought a 4spd from a newer cruiser that didn't have the drum brake on the trasmission(driveline brake) I was told I need to fab up some kind of braket if I wanted to run the stock e-brake in that it would not directly bolt up. Is this true?
I'm trying to figure this one out so I can get my...
Question I was checking the wiring on the cluster the 2 main feeds possitive and negative there is a white/blue wire and a solid white wire one going to the possitive and one to the negative. When I was tracing out the wires today the white/blue wire goes to the fuse panel so it gets power and...
I removed all my hard top windows on my '78 to do some body work too, bit of a pain but when they were out all I did was cleaned them up removed the dirt and crap from them and when it came time to re-install I just used the string method to re-install the windows. You could use some seam sealer...
So The brake light issue is resolved apparently I am not that bright when it comes to setting up the brake light switch! So I grounded the tail lights now both brake lights work re-adjusted the brake light switch lights no longer stay on. I will work on the signal light issue tommorrow.