Brake Questions

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 2, 2006
Threads
10
Messages
31
Location
Abbotsford,BC, Canada
Website
dubmatic.spaces.msn.com
I bought a 4spd from a newer cruiser that didn't have the drum brake on the trasmission(driveline brake) I was told I need to fab up some kind of braket if I wanted to run the stock e-brake in that it would not directly bolt up. Is this true?

I'm trying to figure this one out so I can get my cruiser inspected, then insured for this comming weekend.
 
you need the brake assembly that connects between the rear trany output and driveshaft. Replace the rear xfer seal while your at it. Is the drum and all hardware completely gone? See if there is a small brake drum on the rear output shaft about the diameter of a coffee can and about two inches thick.
 
Back
Top Bottom