Recent content by Webster

You’re probably correct. Not excited to spend $230 for test pipe on top of the $350 for exhaust they sell. I guess if I wasn’t so lazy I could cut off the flanges and use some slip joints.

Not in North Idaho. Just want to buy the turnkey replacement exhaust but they are all CAT back. And my CAT is shot.

Sadly not one of those guys with a shop or welder. Wish I was. Looking for easy button. I've tried to get the local shop to do this and they absolutely refuse to do it. Perhaps if I came with the CAT already missing they'd build me a system from there back.

Anyone have a test pipe they'd sell?

Got it out with pb blaster overnight and some heat this morning. Gentle slight back and forth turns. Thank God that sucker didn’t break. But that PIA short little oil cooler hose. What in the heck ……

Replacing water pump. Have all bolts out except one to far right as you face engine from front (driver side I guess). It feels weird. I think it might be twisting and not turning. I’m afraid it is going to snap So I have it soaking overnight with PBBlaster, I feel it might be inevitable that...

Do you have a tailgate?

Hello all, Can anyone that is running a Weber 38 recommend a guide on proper jetting? Or suggest a jetting that works for them? I need to get a good baseline, or least go back to what was stock (which I don't know how these shipped originally). Most time spent at 2100 feet with my occasional...

I only have his email and PM info. I don’t want to pester but I’d be happy to call him if someone could share a phone number.

Hi all, Looking for recommendations for someone who can rebuild my carb. I’m aware that Jim @FJ40Jim is the goto guru. But I haven’t been able to contact him and don’t know if he is still doing this. thanks!

Well, I’ve done all that. I think. Only thing I can’t 100% vouch for if float setup. My mechanic played with that. By the way he sai the factory settings he found were wrong and would starve the carb of fuel. He kep adjusting. Anyone have a recommendation for the float setting? Got it...

No

After it dies you can see and hear fuel down in the venturies. probably should just replace manifold gasket. I gave sprayed carb cleaner but probably not underneath manifold. I assumed a squirt in general vicinity would get sucked in.

New Weber, I’ve never got it running good. Still original manifold. Not replaced manifold gasket. Are you suggesting maybe a vacuum leak? Pretty confident we’ve eliminated any vacuum leaks but you never know I guess. Just the manifold adapter, not an insulator. I have one I plan to...

That’s the exact regulator I am running. Fuel overflowing into venturis. Stumbling and stalling out. Hard to start initially then runs fine until it does it again.