Recent content by tronic

I installed some electric fans after those pics were taken.

my setup is a little different, but worked for me, will be installing a flapper when I get back to the cruiser in a few months.

I haven't been on for a few years, but here are some of the pics that I took while I built up the cruiser in a small mountain town, San Jose de Las Matas, Dominican Republic. It was built with hand tools, arc welder, hand drill, and angle grinder. Did not have access to my tools or machines...

BJ40 came with drums all around, are the knuckles the same? Can I run long fields with no problem? And will the mini brake components drop right on?

Im building a bolt on hitch like the ones listed on the MAF site for my BJ which is overseas. I bought the angle iron and square tubing needed and need the bolt hole spacing on the factory bumper. Does anyone know the bolt hole diameter and spacing?

Thanks for the help, hopefully someone who has done the switch can chime in one of these days. Dan

do you still have the passenger side door handle, bear claw catches (both sides), kick vent springs, roll bar? If so please send the total with shipping to 10009. Thanks Dan

I need a passenger side door handle, and the door locking components if you have them.

My response was a direct reflection of your phrasing, I have dealt with countless people on here that were nothing but helpfull, I meant no disrespect but you left me no option. If anyone happens to know the factory threads and sizes for the sending units on a 1979 B engine I would be gratefull.

I WOULD if the truck were in this country, I am sourcing all the parts for my BJ that is located in the caribean, either be productive or avoid responding. It makes life easier for everyone.

no one knows what the factory threads are for the sending units on a B?? Is it the same as the 3B?

I have tried to locate the thread sizes so that I may order adapters for a set of mechanical guages I picked up on ebay, but no such luck. Its a 1979 B series, interested in water temp, oil temp, oil pressure, and an idea for trans temp.

I have a 79 BJ40 with a B engine, and will be upgrading the brakes to disks all around. I purchased a 1993 toyota pickup 4x4 MC and booster with the 4 stud bolt pattern, from what I have read it will work on FJ's but would like to confirm it will work on a BJ. It is a 4 wheel disk, non-ABS...

I have a 79 BJ40 with a B engine, and will be upgrading the brakes to disks all around. I purchased a 1993 toyota pickup 4x4 MC and booster with the 4 stud bolt pattern, from what I have read it will work on FJ's but would like to confirm it will work on a BJ. It is a 4 wheel disk, non-ABS...

Thanks for the info, will just go for the bolt on brackets and call it a day. Dan