Recent content by TRAILTOYZ

Metal Tech FJ43 cage is in. Bent up some lower bars between the b/c pillars for jumpsuit belt mounts. Found some clip on belts from an HH60 copter on ebay which work great.

Need the shifter linkage between top of the gearbox to the shifter arm. Pls msg if you have available

Nice 40! I'm up in Monticello. Lots of cruisers up here.

that a broken solder joint?

be cool if you could hookup a backup camera through that screen

And not sure what this connector is for. has a single wire run into it prob for a + lead

So, fuel temp and oil pressure don't work. There is a 3 prong connection on the back of the cluster and there is a 3 prong female connector hanging out of the harness behind the dash but it's a few inches too short to reach and doesn't look like it would connect. Any idea what this plug is for?

was it pretty easy to mount up? got their half doors and thinking about getting the tailgate as well.

You either need thinner spacers that attach to hub then wheel or you need new wheels. I had factory wheels widened since they have way less offset, 2.75" I think. factory are 5.5" wide so you could run 33x10.50 on them, or widen them to 8.5" like I did and run a 12.50 wide tire

What paint did you use on the roof?

And fixed the anti inversion shackles. but trying to find new bushings for the frame side hangars

Alcan was great. spendy and bit of a lead time but the springs ride exceptionally well.

Update. 4" Alcans and Bilstein 5125's. widened factory wheels, powdercoated with hubcaps. 35" geolanders. great ride. Also added Aqualu half doors, 12k winch, LED headlight and driving light bulbs, new TCase and driveshaft and Yellow Top Optimas

Got the lift and tires on. Got the half doors back from the paint shop and installed

Saw on a Proffitts cruisers vid they used an FJ60 contact thingy to solve that issue