Recent content by tornio

yes there is no evidence in any manual but probally this tube is not the cause of the problem

yes i know it , my 40 has this earlier b engine on the 45 I changed the oil of the pump a little while ago. I know your documentation about air problems and the others , GREAT WORK THANK'S to share for the air , i have a lot of copper whasher and i bought the primer pump because I suspect...

By any chance, do you know what the blue circled piece means or what it is for? THE FSM call it injection pump cleaner ... ?

What do you think the copper tube is used for? at that point it should be the air bleeder.... black circle , at this point i think that i can cut / delete this tube and the connection at feed pump inlet ... By any chance, do you know what the yellow circled piece means or what it is for...

i discovered these photo : this is my 45 when the PO did the camper conversion (1996) and this photo before conversion you can see that there was the same hose/pipe orientation but this was in the 1996 ... the truck is an 1976 so there is no warranty that the feed pump was factory.... i'm...

hi duncanrm, my 40 and my 42 all have inlet toward the tank and outlet toward the filter... but if the feed pump is from a different vehicle why the copper tube seems factory ?

Hello guys, looking for a possible source of air into the fuel circuit I noticed that my lift pump (feed pump) is connected the wrong way: in the manuals and photos I have seen here on the site, the inlet is towards the tank and the outlet towards the radiator with a metal tube that carries...

no no no...sometimes things seem to go right... yes i have 13,7 14,.. V but only without load ... So remembering an Rudi post about VR I opened the VR and after checking the resistor i tried to adjust the arm with these result the multimeter on the right is a "battery voltage" the other on the...

hello ! the smoking hj : waiting for the new diaphragm i tried the liquimoly diesel purge and i have to say that it works now i have less smoke ! i'll change the diaphragm in any case but i think that the smoke don't seems cause from a governor problem.... i have no high rpm when idling i have...

hello duncarm ! "nice to see you" again ! i ordered yeasterday two diaphragm one for the 40 and one for 45 , but i think injector are "low" ... WE WILL SEE... i have the 3 wire regulator and a good multimeter we will see what is the problem .. the " only " strange things is that there is a...

thanks greek cruiserhead ! yes it will be our (me and my new girl) second home but at this moment i have to fix some issue .... a lot of smoke.... alternator charge16 v try to lighten the dinosaur now 32 qli / 7050 lbs and the engine struggles :deadhorse: I probally open a more speficic...

Hello to all you guys ! a lot of time away from this wonderful forum ...but you Know life is strange ... tu cut a long story short : 4 years ago, after 10 years i left my "old" girlfriend so i had to move to new house... at the same time i have changed job company...a lot of new things to...

hi guys, i have had the same problem : normally no oil in the t-case

few pictures to judge it right but.... for what i see.... 30k is too, too , too much if you ask me too !!

i have this one : and the replacement cartdrige is only About 30 euros , in the states maybe cheaper ! racor is a good company for diesel water separator , don't buy 2 micron version is to much for a pre-filter buy a 20 micron cartdrige the factory diesel filter is 5 micron