-
-
Tinman replied to the thread Fuse & Relay layout VDJ76.Thanks -
This is a good start.
-
Tinman replied to the thread HZJ73 fuel economy.I would be pretty happy with that. It is about 25MPG Austr gallons not US gallons.
-
Tinman reacted to sodafeld1's post in the thread Has anyone got GVM upgrade on a HZJ75 series here in Australia. with
Like.
I upgraded springs on my hj75 if that helps, used dobinsons heavy duty front and back. I can carry 500 kg constant without sag. I don't take more than a tonne in the troopy though and rather use the tandem trailer if I have more weight than... -
Tinman replied to the thread Has anyone got GVM upgrade on a HZJ75 series here in Australia..Yes mate. The engineer approval cost me about $350. He assessed it, fitted the mod plate and provided the documentation which I then had to take to transport. I had already done all the suspension upgrad, 2“lift, brake lines, load proportioning...
-
2011 VDJ76. I am after a diagram of what relays are what for the panel on the left hand side footwell.
-
-
Tinman replied to the thread HZJ75 front left wheel bearing working loose?.No
-
Tinman replied to the thread HZJ75 front left wheel bearing working loose?.That is what I am thinking.
-
Tinman replied to the thread HZJ75 front left wheel bearing working loose?.The 48ft/Lbs is about 68Nm.Yes preload the bearing to spec and then back it off. Haven’t seen the 20ft/Lbs before but that is about it. We would always preload and give the wheel a good spin. Then back it off to just tighter than had tight which...
-
Tinman reacted to Squash's post in the thread HZJ75 front left wheel bearing working loose? with Like.
Interesting that one of my manuals tells us to pre-load to 65ft/lbs vs 48, I then loosen and torque inner nut to 20ftlbs rather than factory spec... especially with bigger tires. Make certain your thrust washer is in decent shape and bend the...
-
Tinman replied to the thread HZJ75 front left wheel bearing working loose?.That was my initial thought. But when I got home and did the overhaul I replaced the thust washer and it has come loose again.
-
-
Has anyone had this issue and what was the cause? The problem initially started after getting water in the swivel housing which intern ended up in the hub ceasing the outer bearing. The bearing spun on the stub axl, thust washer broke the tab...
-
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…
