Recent content by Tinman

They can be pretty slow to deliver at times. Not quite sure how the business operates. They do have mostly genuine parts and are way cheaper than Toyota. I only purchase parts through them if I don't need them in a hurry. Another online PartSouq Off shore company but ship pretty quickly.

Bugger.

I have an 80 series one and it look like it will fit on my 75 can I use it? The bolt holes appear to be the same.

I could hear it changing but it must have been only half opening. It was drawing fuel from both tanks. Replaced it and it is fine now.

I have a vibration/rattle coming from my tailshaft especially when it starts to labour. It has gradually got worse over the years. The yoke has some play and would account for some of the noise. When I pump it full of grease it quietens it down for up to a week. Doesn't stop it though...

I am chasing a wiring diagram for the fuel tank change over valves. 1991 HZJ75. Cant use the rear tank at the moment. Going to check it out today, has anyone had this issue. Any tips? Going to start by checking the valves and go from there.

Thanks

I would be pretty happy with that. It is about 25MPG Austr gallons not US gallons.

Yes mate. The engineer approval cost me about $350. He assessed it, fitted the mod plate and provided the documentation which I then had to take to transport. I had already done all the suspension upgrad, 2“lift, brake lines, load proportioning valve modification. can’t remember his name of the...

2011 VDJ76. I am after a diagram of what relays are what for the panel on the left hand side footwell.

No

That is what I am thinking.

The 48ft/Lbs is about 68Nm.Yes preload the bearing to spec and then back it off. Haven’t seen the 20ft/Lbs before but that is about it. We would always preload and give the wheel a good spin. Then back it off to just tighter than had tight which would be around the 20 mark. my book says 59Nm...

That was my initial thought. But when I got home and did the overhaul I replaced the thust washer and it has come loose again.

2021 upgrade