Recent content by thedoughboy

This is what I used. It worked well. There are others too. https://www.amazon.com/dp/B095JYYQ2P?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_5 https://www.amazon.com/dp/B09SPCSGP9?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_5

@JimmyA23 When you say you can't bleed the rear, what exactly are you doing when trying to bleed the brakes. There are lots of threads here and most end with using a pressure bleeder. Ask me how I know :bang:. Before replacing any parts you might want to invest in one. The reason I say this...

I just did window runs (OEM) and Dorman regulators with motors (Rock Auto). Window speed has increased dramatically. I did adjust the regulator allignment which helped as well. This thread is a good one https://forum.ih8mud.com/threads/window-motors-working-barely.1354355/#post-15798909

^ x2

Enter the part numbers on this website. It'll do the rest!

@jpoole Thanks for the reply. How are you activating the ABS pump? I just found this thread that shows how to activate the ABS pump!

1995 FJZ80 I replaced my soft brake lines with a set of Slee SS lines. Everything was going smoothly until the Front PS hardline leaked. I ordered the #9 line and waited 3 days for it to arrived. I installed it and begain bleeding the system with a one-man pressure bleeder. When I got to...

@Stew80UT @bicycleagent003 or anyone else with knowledge on this. Can you install heated seat elements under the Wet Okole or Coverking neoprene seat covers?

These are cheap, look decent, and last about 2-3 years.

@wthomp10 So far, so good. No issues to report.

@Jacob80450 If you live in the Bay Area take it to Mudrak in Sonoma. You won't need to ask any questions as they basically have been there, done that. It'll cost you. They'll most likely recommend rebuilding the topend of your engine. Can't speak highly enough about Gary and his crew.

@Malleus and @jonheld Have you ever tried the POR-15 caliper paint?

One thing to note, @LLTB, I did NOT attach the resistors to the body panel. The resistors get hot, real hot, and melted a hole in the tail light housing. I have since replaced the housing, removed the resistors, and just deal with the cruise control when it cancels.

https://partsouq.com/

An angle grinder with a wire wheel attachement makes quick work of surface rust. Be sure to ALWAYS wear gloves and eye protection when using this method. A Kn95 mask is part of my approach too. Rust Bullet and/or POR15 are well documented on MUD and work extremely well for treating rust.