Recent content by tewald

Does this 12” model interfere with the sun visors?

Did you ever resolve your charging problem? I’m suddenly having a very similar problem after replacing the alternator ~9 months ago.

Very good condition, factory front bumpber (with fogs) and side steps off my 2002 LC100, dark grey mica painted. Also have factory 3x 16” rims, UCA’s, roof rack and engine cover. Moving next week and need gone or going to the dump.

Can anyone confirm if the rear window molle panels will fit with a Speski barrier installed?

Finished up my Switch-Pros install so now I can finally get the rest of the lights that have been sitting in boxes for 6 months installed. Fabbed a quick mount out of 3/16ths and secured with a nutsert and treaded rod into an existing spot in the wheel well. So far I have the ARB air Compressor...

Any update on clear?

🙌🏼

Thanks for the advice. I was waiting for ranma21 to restock the Depos, but that price had me thinking.

I ran across these Chinese 2006+ style headlights at an irresistible price. Has anyone taken a chance on these? Really curious on the fit and finish. https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.com%2Fulk%2Fitm%2F173859987865

Interested in a clear set when available.

4 lights total (2 on each side) would put off a ton of light... they are about 500 lumens/light in a nice broad flood pattern.

What about frame mounts specially for KC cyclone LEDs as rock lights? Also mounts so the lights could be mounted under the hood.

Is anyone out there running ARB’s flat mesh roof rack and can comment on how you like the mesh as an attachment point? Pictures would be appreciated.

Thanks for the reply. Like I mentioned, I already have a SwitchPro panel in the engine compartment but was trying to avoid running another wire through the firewall. I ended up just using an add-a-fuse and tapping into the AHC-b fuse that showed to be constant power on the multimeter. Mine is a...

Does anyone know a good constant 12v source near the driver side kick panel that would be a good candidate to tap into? I am wiring a SolidKit voltmeter that already has an in-line fuse. The aux battery I was easy as I already have the cigarette/usb outlets wired for constant power via a fuse...