Recent content by TeeDiggs

Nice! Glad the trip went well. Where in MT was your end destination?

Awesome, thanks guys. Do you think some bulk Napa cut-to-fit would be fine here, as long as it were rated for fuel/vapor? The others are in pretty good shape since I've replaced (unfortunately one by one)

Typical hard and cracked hose... Which hose is this exactly? I was thinking it's okay to replace with something from Napa or the like, cut to length?

Yep, in the same vein of what I was going for in looks, I just really enjoy the industrial look. I'm guessing they'll sling mud pretty good, but hopefully they won't be too loud. At least so far, they are surprisingly quiet though they are brand new of course

Finally finished some plans I've had for a while... OME Medium lift w/ front spacer, repainted steelies and Toyo MT 255/85R16. I really wanted a skinnier 33, and one that would sit clean and flush with the fenderless body :wrench:

Thanks all! getting it back on the ground, turning the wheels and then using a pipe wrench to rotate the panhard rod just a smidge worked out in the end for me.

@whitey45 is that as-in everything is installed and you've let the vehicle back down on the axle with full weight on wheels, I.e last step? And just to make sure, you're referring to the panhard rod, not tie rod correct? Should I finish installing the front and just get this last? Thanks!

Im in the middle of installing an OME medium lift and unbolted the PS bolt from the panhard when trying to remove the springs yesterday and now am having a hell of a time getting the bolt to line back up to install. I removed all springs/shocks again. See photos, the bolt in the center of photo...

Also replied. Thanks Rick!

I'm in, I will shoot Zach an email too as stated on pg. 1. Thanks for getting a new buy going! 1) BMThiker 2) montypr (505) 440-5281 3) the stig 4) hardydanger 5) lanecruiser 6) smoothcruiser 7) strangerdanger 8) western flyer 9) TheKeeper 10) Enders (757)817-7435 (Ben) 10% off reached 11)...

Ditto, I have a '96 and hear a fan, I haven't been in there but still stock radio and all as far as I know.

Here's a visual, you can see them up directly under windshield.

Dropped the 80 off to a body shop a few days ago to have some body holes welded up. When I picked it up today, a new engine knock/tapping is very present. I've occasionally had some minor tapping sound in the past year or two on very cold winter mornings until the engine warms up, but this is...

@alia176 Not sure about others, but I've treated Amayama as more of a place to get some things that might be tougher to find or non-US bits and pieces (like a few things for my manual tranny swap).

What will you be moving into @Finnyfam60 ? a 100? I stumbled onto this update and then noticed I originally replied to this as post #2, 4 yrs ago. Time flies! Take care