Recent content by SouthTxGX

$50 shipped? I’ll leave this up for a couple days and then it’s going in the trash.

I add about a quart every oil change. Eventually it’ll all be fresh

Gx460 SDHQ Switch Pros overhead panel mount. Still new in package. Was going to switch over to this from my current setup but it never happened and I’m tired of looking at it. Retails for $119. $65 shipped usps priority with tracking.

Lotus adapter is sold. These have been sitting in my drawer setup unused and I’m tired of them being in the way. $90 for the prolink and $50 for the lotus adapter. Shipping is included in the price. Tracking will be provided upon shipping. Payment through PayPal or Venmo.

I ordered all oem stuff. I figure the original stuff lasted nearly 150k miles so it’s worth it. Ordered it all from bell Lexus and saved a good chunk compared to buying from the Toyota dealer.

I should mention that I’m changing them due to being soaked with gear oil due to a bad rear axle seal.

Definitely gonna watch some videos beforehand. Thanks!

I’ll be replacing my rear brake pads, rotors, and parking brake shoes later this month so I’m looking for advice on tools and techniques to make it easier for someone who hasn’t done this in close to 20 years and the last time I messed with brake shoes was on a 62 Chevy pickup. I’ll be picking...

It’s not the 20 ton press I need to do the axle bearings, but I got these today. Best part is I came out way ahead on my side of the trade and they'll definitely come in handy.

Well, when it rains it pours. I believe this is the source of the leak I had previously and it just took forever to show back up. Thoughts on Dorman hubs with koyo bearings?

Someone spilled roofing nails on a street here. Had nails in all 4 tires of the Tahoe. There were 6 other people at discount tire getting their fixed too.

@Washingtontaco would the tone ring also need to be replaced or does it just get off center due to the bearing and cause the code?

Well it’s already been ordered and it was cheap enough that if it’s not the problem it won’t be a big deal. I was already planning to order a couple hub assemblies from one of the vendors anyway for spares so I’ll just have to do it sooner.

Don’t you put that bad juju on me Washingtontaco lol. Didn’t feel like dropping another $300 just yet, but if the wire doesn’t fix it a new hub assembly is next.

Cleaned up everything underneath to try and pinpoint where the unknown fluid was coming from and now everything is dry and I haven’t seen anything leak since. I’m guessing the magnesium chloride that was in the dirt was pulling moisture from the air and the fact that I tried washing some of it...