Recent content by pzengilowski

Other than an oil change (if you subscribe to the need for that interval) I don't see the need to do much, if anything else unless it coincides with routine maintenace schedule. Not sure about the squal - wheel bearings usually don't do that - instead they drone/grind. More likely is brake...

+1 for this reply - it is most likely the actuator. Simple repair - takes about 30 mins to r/r the panel and install the new actuator. I may have a spare that I'd be happy to send if that'd be helpful to you.

Hadd this same problem on a 2001 LX, turned out to be a failing actuator. Don't think there's a way to fix it without removing the door panel. There are a number of threads detailing the procedure including links to inexpensivr actuators that are incredibly helpful. I started with the...

I just picked un an SC300 that had been sitting for a year - replaced distributor cap, rotor, coil, plugs, wires and all fluids just to have a baseline where I knew that things were fresh - car ran fine beofre i did all this. The only surprise was plug seals that were leaking oil into a couple...

Hi, I did this a few years ago nd her's the partslist I got from CDan at the time. If I were doing it again, I'd add in the LC Torsion bars as well. They add more expense and there are different opinions as to whether they are necessary. 2 2 0 48511-69625 M005 ABSORBER S 41.88 31.41 62.82...

Would you tak $100 shipped for the pair?

Hi, I'd be interested in the sensors and the globes - are you willing to sell them separately and what are you hoping to get for them?

A couple months ago the AHC system started acting up on our 2001 LX470. First the fromt was riding way high, then intermittently would stop working completely. That was very unpleasant and likely dangerous as there was no damping action whatsoever. Took it to the shop who tried to bleed the...

Didn't ask, I was too eager to get in and drive it. The instructions from Doug Thorley specified jacking the engine up 2" and made no mention of removing the steering column. This was a great thing you folks put together this group buy and provided all the installation tips and support. I...

Headers installed! Got the LX back from the mechanic today. Install went smooth, only heartburn was getting the studs out - vermont winters caused virtually all of them to sieze. I'd asked them to order a complete set, so they're all new now. Also put in new 02 sensors. They did not have to...

Nick Thompson Doug Thorley Headers Sales Manager - International/Domestic 1220 W. Railroad St. Corona, CA 92882 Toll Free: (800) 347-8664 Direct: (951) 739-5903 Cell: (951) 733-8658 Fax: (951) 273-3616

Installation tips I sorted through the posts and compiled this list of tips/suggestions for installing the headers. I plan to give this to the shope doing the installs and hope that you folks can help make sure it's right. Hopefully, it'll also be helpful for anybody that does this in the...

Thanks, I'm pulling all the tips I can from this post and will put them together for them. The good news is they "get it" that they can do this through the wheel wells and have had good experience with Doug Thorley products in the past, so I'm optimistic. Biggest worry will be how badly the...

Thanks for offering to help, I think the biggest issue is going to be convincing my mechanic that they can be replaced through the wheel wells in 4 - 6 hours instead of the books 10 hours per side. The cost was $540 + UPS ground shipping which I felt was great of Nick to offer.

Headers still available at group buy price I just ordered a set of headers from Nick and he offered the group buy price. Says he still has more on hand so anybody that didn't get in on this originally can still do so. Mine are shipping tomorrow.