Recent content by Nishiki

@2MinutesTurkish, sure, send me a CAD file and diy instructions. Thanks for volunteering.

Yeah, due to lift. No caster plates or ball joint spacers or anything? Was hoping to avoid buying the control arms. $600 seems excessive for a piece of bent steel.

Old thread revival. Do they have something g similar to this for a Lx470, my vehicle is off by 3 degrees castor. I really need to fix it. Alignment shop can't.

I will get on tonight after work and respond. Thanks for all the help gentlemen.

Please elaborate. I would greatly appreciate it.

I am going to make a new thread, but I was wondering if any of you guys could chime in here... I have the torsion bars cranked all the way, now get a 6.8Mpa reading. The ride is very springy, most recent change has been additional height added to the vehicle via increased AHC raise(I have cut...

Yes, they were marked. I believe that the right was shorter.

Part installed -- P/N 48231-6A420.

Standard, used. No coil compression tool is needed. I do recommend three jacks total to lower and raise certain things. In this order: Jack car up, put stands under for safety Remove sway bar link (use a jack to remove the tension by raising link from around axle area) remove bottom shock link...

@jjrowe , I installed the part and WOW! These are perfect. The rear pressure went from 8.4Mpa to between 5.7-6.1Mpa depending on reading at the time. I will run the test again after some riding on the mountains this weekend, but this I believe is the holy grail to anyone trying to bring down...

They show that they will arrive on Monday. I will probably install that same day. Give an update by no later than Thurs of next week. EDIT: I actually purchased a pair off of eBay, an old LC100 series rears. Will post stats on those.

I will update when I get them. I haven't forgotten. I just can't seem to find an acceptable source. Looked at the 1999s and they had rust. Which was a no go. If anyone knows a good source near AZ please inform. Thanks.

Bump.

@Trinny, thanks for the input. I am actually getting some old 1999 LC non-ahc springs right now from Cruiser Outfitters and I will be updating the MPa changes and adjustments as I go though them. Seems like people are looking for pics for a TB adjust and a Bleed, so maybe I will provide a HowTo...

Ordering springs right now through Cruiser Outfitters as we speak. Will update in my post on MPa changes and lift total.