My setup is super simple. Cheap renology panel bolted to the hood, ran to a controller in the back then controller to my starting battery (i do not have duals... yet)
This panel has been mounted here for years after being unhappy with the loss of rack space and poor charging it got behind my...
More than likely someone bought it online and returned it?
https://www.walmart.com/ip/Toyota-Genuine-Oil-Filter-90915-YZZD3/143155999
Still cheaper at the dealer
https://parts.toyotaofdecatur.com/p/Toyota_1994_Land-Cruiser-45L-AT/Engine-Oil-Filter/69384567/90915YZZD3.html
I know a few here have them/ made them/ bought them.
Where can I get a set? How can I build a set?
Anyone have the PN for the flange so I can weld some pipe up?
I don't use any sway bars. I have a 94, 35s, OME J springs, and I'm always loaded with gear, boxes on top. I don't have any issues with it being to squishy on the roads, and I spent a lot of time in northern California and Colorado. Only issue I had (before the LSPV delete) was under very hard...
Just adding info since this is a main thread found while searching.
1.4 rebuild kit - Alternators, Alternator Parts, Starters, Starter Parts & Repair Kits - https://www.aspwholesale.com/starter-rebuild-kits/denso/off-set-gear-reduction-osgr-/rebuild-kit-p18304.html
2.0 rebuild kit -...
Little time- Check
FSM sensitive Question- Check
Flame Suit- Literally wearing a nomex jumper, so double check
Who's reusing or resused the upper intake gasket or using and RTV product for that? Or are people using auto store alternatives? The mating surface between the two looks well machined...
You should really hope you don't have a removable cover. Or someone swapped that rear. If you're looking for a stronger option, you could also weld on some plate or diff rock guards.
@Vasiliy that's interesting to know. It shows that It's still running through the VSV, however? I may take the VSV from under the intake and put it more inline like the coil version.